Filter
Top Products
English
10
Assembling Your Bowl-Lift Mixer
To Attach Bowl
1. Turn speed control to “O”.
2. Unplug Stand Mixer or disconnect
power.
3. Place bowl-lift handle in down
position.
4. Fit bowl supports over locating pins.
5. Press down on back of bowl until
bowl pin snaps into spring latch.
6. Raise bowl before mixing.
7. Plug into proper electrical outlet.
To Raise Bowl
1. Rotate handle to straight-up position.
2. Bowl must always be in raised, locked
position when mixing.
To Lower Bowl
1. Rotate handle back and down.
To Remove Bowl
1. Turn speed control to “O”.
2. Unplug Stand Mixer or disconnect
power.
3. Place bowl-lift handle in down
position.
4. Remove flat beater, wire whip, or
dough hook.
5. Grasp bowl handle and lift straight up
and off locating pins.
To Attach Flat Beater,
Wire Whip, or Dough Hook
1. Turn speed control to “O”.
2. Unplug Stand Mixer or disconnect
power.
3. Lower bowl by rotating bowl-lift
handle downward.
4. Slip flat beater on beater shaft.
5. Turn beater to left, hooking beater
over the pin on shaft.
6. Plug into proper electrical outlet.
Raise