Filter
Top Products
11
Top vented models
NOTE: Features on your
dishwasher may differ
from model shown.
Option 1:
For Top vented models with a factory-supplied stainless or
painted full front panel:
1. Remove the carton containing the factory-supplied full
front panel.
2. Remove the handle package from the front of the
shipping base.
3. Remove the inner panel from the door.
4. With a TORX
®
screwdriver, remove three screws from
both sides of the door. Hold the inner panel up while
removing the screws.
align top edges
2 screws
10. Install the two #8-18 x 1-3/8" screws from the literature
package in the top corners of the door.
11. Align the top edge of the full front panel with the top
edge of the console and secure corner screws.
12. Tighten the two screws installed in Step 9.
13. Reinstall and tighten the remaining screws in the inner
panel.
5. Gently set panel aside.
NOTE: Some models have 4 screws per side.
6. Lay the factory-supplied full front panel face down on a
protective non-scratching surface.
7. Place the inner panel on the back of the full front panel
as shown and attach, using the four #10-16 x 3/8" screws
in the literature package.
8. Attach the factory-supplied full front panel, inner panel,
and handle assembly to the door.
9. Reinstall the two uppermost screws into the inner panel,
do not tighten completely. This will hold the full front
panel in place on the door frame.
top of panel
Install the door handle (on some models)
IMPORTANT: Do not scratch the front panel during this
procedure.
1. Remove the Architect™ Series handle, plastic washers
and two screws from handle package.
2. Attach the handle to the factory-supplied full front panel
as shown.
do not remove screw.
screws
4 screws
full front panel
inner door panel
2 screws
screws
inner
door
panel
1. Remove the Pro Line™ Series handle and two screws
from handle package.
2. Make sure plastic spacers are still attached to the door.
3. Attach the handle to the factory-supplied full front panel
as shown.
Pro Line
™
Series
plastic spacers
film that is
not
to be
removed
Install door panel (on some models)
top vent