KitchenAid 8573714B Dishwasher User Manual


 
3
Tools needed:
Utility knife
Needle-nose pliers
Tape measure
Flat-bladed screwdriver
#2 Phillips screwdriver
Side cutting pliers
Pencil
Sandpaper
Level
Adjustable wrench that
opens to 1¹⁄₈" (29 mm)
7 mm socket wrench
5 mm socket wrench
5 mm open end or box end
wrench
Electric or hand drill
1¹⁄₂" hole saw
Valve (sized to fit hot water
supply line) with ³⁄₈" male
compression fitting
Protective floor covering
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools
listed here.
Parts supplied:
Located in drawer:
2 flexible trim pieces (for sides)
Edge protection
Hose clamp, screw type
Washer
Drain hose support
Drain hose connector
Hose clamp, wire type
11, ⁵⁄₈long, #8 Phillips head wood screws
Moisture protection tape
3, 1hex head wood screws
3, ⁹⁄₁₆washers
INSTALLATION REQUIREMENTS
Location Requirements
IMPORTANT: Observe all governing codes and ordinances.
Failure to meet codes and ordinances could lead to fire or
electrical shock.
Proper installation is your responsibility:
Contact a qualified installer to ensure that the dishwasher is
installed to meet all electrical and plumbing national and local
codes and ordinances.
Install the dishwasher as specified in these instructions.
Have everything you need to properly install dishwasher.
Protect dishwasher and water lines leading to dishwasher
against freezing. Damage from freezing is not covered by the
warranty.
This dishwasher is manufactured for indoor use only.
Install the dishwasher in a cabinet cutout that is level, will hold
weight up to 104 lbs. (47 kg), and is in an area suitable for its
size and use.
Product dimensions
23⁷⁄₁₆"
(59.5 cm)
22⁷⁄₁₆" *
(57 cm)
16³⁄₃₂"
(40.9 cm)
side
attaching
tabs
20
¹⁵⁄₃₂"
(52 cm)
drawer open
* If custom wood panels are to be used, the product depth is specified with an
¹¹⁄₁₆" (18 mm) door panel thickness.
NOTE: Product shown with front panels for dimension purposes.
Greatest length from product exit point to hookup (does not
include allowance for drain loop):
Drain hose 88 ⁹⁄₁₆(2250 mm): Extension kit available - part
no. 8194400
Inlet hose 68 ⁷⁄₈(1750 mm)
Power cord 44(1125 mm)