Filter
Top Products
f t
1” min. - IO-3/8” max.
upper chimney height
23-518” lower
chimney height
24-518” min. -
34-314” max.
overall
chimney
height
I
t
10-l/4”
canopy
support IP
structure
/
- upper chimney
- lower chimney
- canopy
\
I
24” min. bottom
of canopy to
cooking surface
cooking surface
-f
36” base
cabinet
height
8’ min. -
9’ max.
ceiling
to floor
Important: Observe all governing codes
and ordinances.
Proper installation is your responsibility:
l
Have a qualified technician install this range hood.
l
Comply with installation clearances specified on the
serial/rating plate.
Serial/rating plate is located inside the range hood on
the rear wall.
Range hood location should be away from strong draft
areas, such as windows, doors and strong heating
vents.
Cabinet opening dimensions that are shown must be
used. Given dimensions provide minimum clearance.
Consult your cooktop/range manufacturer installation
instructions before making any cutouts.
Grounded electrical outlet is required. See “Electrical
requirements.”
Ductwork must terminate outdoors,
All openings in ceiling and wall where range hood will
be installed must be sealed.
Electrical Shock Hazard
It is the customer’s responsibility:
*To contact a qualified electrical installer.
*To assure that the electrical installation is
adequate and in conformance with National
Electrical Code, ANSVNFPA 70 - latest edition’,
and all local codes and ordinances.
Failure to do so could result in fire, electrical shock
or other personal injury.
Electrical Shock Hazard
*Take special care cutting holes into ceiling or wall.
Electrical wires may be concealed behind the
ceiling or wall cover and contact with them could
result in electrical shock.
l
Locate any electrical circuits that could be
affected by the installation of this product and
disconnect power circuit.
Failure to do so could result in fire, electrical shock
or other personal injury.
Personal Injury Hazard
Reaching over a heated cooking surface should be
avoided. To reduce the hazard of being burned, the
range hood should extend a minimum of 5 inches
out from the bottom of the cabinet.
Reaching over a heated cooking surface could
result in a serious burn.
Tools needed:
- l-1/4” drill bit
caulking gun and
saw
flat
duct tape
allen
wrench
Parts needed:
2 U.L.-listed, l/2” conduit
connectors
power supply cable
wall or roof cap
metal ductwork
Mobile home installation
The installation of range hood must conform to the
Manufactured Home Construction and Safety Standards,
Title 24 CFR, Part 3280 (formerly the Federal Standard
for Mobile Home Construction and Safety, Title 24, HUD
Part 280); or when such standard is not applicable, the
Standard for Manufactured Home Installation 1982
(Manufactured Home Sites, Communities and Setups),
ANSI Z225.1/NFPA 501A, or with local codes.
Four-wire power supply must be used and the appliance
wiring must be revised. See “Electrical requirements.”
Copies of the standards listed may be obtained from:
l
National Fire Protection Association
Batterymarch Park
Quincy, Massachusetts 02269
Page 1