Filter
Top Products
English
R-8
Flat Beater, for normal to heavy
mixtures, such as:
cakes biscuits
creamed frostings crumpets
candies meat loaf
cookies mashed potatoes
pie pastry
Dough Hook for mixing and kneading
yeast doughs, such as:
breads coffee cakes
rolls buns
Using Your KitchenAid
®
Attachments
Beater To Bowl Clearance
Wire Whip for mixtures which need
to incorporate air, such as:
eggs sponge cakes
egg whites mayonnaise
heavy cream some candies
boiled frostings
Model 5K45SS:
• Lift motor head.
• Turn screw (A) slightly to the left to raise
flat beater and to the right to lower flat
beater.
• Make adjustment with flat beater, so it
just clears surface of bowl.
Your mixer is adjusted at the factory so that
the flat beater just clears the bottom of the
bowl. If, for any reason, the flat beater
strikes the bottom of the bowl, or is too far
away from the bowl, clearance can be
corrected as follows:
A
Model
5K5SS/5KSM5/5KPM5
• Place bowl lift handle in
down position.
• Turn screw (B) slightly
to the left to raise flat
beater and to the right
to lower flat beater.
• Make adjustments with flat beater, so it just
clears surface of bowl.
NOTE: Flat beater must not strike on bottom or
side of bowl when properly adjusted. If beater or
wire whip is adjusted too close so that it strikes
bottom of bowl, coating may wear off of beaters
or wires may wear through on wire whip.
Scraping sides of bowl may be necessary under
certain conditions regardless of beater
adjustment. Mixer must be stopped to scrape
bowl or damage to mixer may occur.
Bowl, flat beater and dough hook may be
washed in an automatic dishwasher. The
wire whip and these other basic accessories
can be cleaned thoroughly in hot sudsy
water and rinsed completely before drying.
Lubrication: Motor bearings are self-
lubricating and should require no further
attention under normal use.
ELECTRICAL SHOCK HAZARD
ALWAYS BE SURE TO UNPLUG
MIXER BEFORE CLEANING TO AVOID
POSSIBLE ELECTRICAL SHOCK.
Wipe mixer with a damp cloth. DO
NOT IMMERSE IN WATER. Wipe off
beater shaft frequently, removing any
residue that may accumulate.
!
WARNING
Care and Cleaning of Your Mixer
B
Your mixer is adjusted at the factory so that
the flat beater just clears the bottom of the
bowl. If, for any reason, the flat beater
strikes the bottom of the bowl, or is too far
away from the bowl, clearance can be
corrected as follows:
See the Stand Mixer Attachments Use and Care Guide for speed settings and operating
times.