Filter
Top Products
26
PRODUCT DATA SHEETS
Base Grille Water Filtration System Model WF-NL300/NL300
Capacity:
300 Gallons (1136 Liters)
Service Flow Rate:
0.5 GPM (1.89 L/min.) @ 60 psi.
Base Grille Water Filtration System Model WF-L500/L500
Capacity:
500 Gallons (1893 Liters)
Service Flow Rate:
0.5 GPM (1.89 L/min.) @ 60 psi.
■
It is essential that operational, maintenance, and filter
replacement requirements be carried out for the product to
perform as advertised.
■
Model WF-NL300
Change cartridge at least every 6-9
months. Use replacement cartridge NL 300, part# 4392857.
2000 Suggested retail price of $29.95 U.S.A./$39.95 Canada.
■
Model WF-L500
The filter monitor system measures the
amount of water that passes through the filter and alerts you
to replace the filter. When 90% of the filter’s rated life is used,
the filter indicator light changes from green to yellow. When
100% of the filter’s rated life is used, the filter indicator light
changes from yellow to red, and it is recommended that you
replace the filter. Use replacement cartridge L500, part#
4392857. 2000 Suggested retail price of $29.95 U.S.A./
$39.95 Canada.
■
The product is for cold water use only.
■
Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after
the system.
■
Refer to the “Assistance or Service” section for the
Manufacturer’s name, address and telephone number.
■
Refer to the “Warranty” section for the Manufacturer’s limited
warranty.
Application Guidelines/Water Supply Parameters
*
Test requirement is 0.15 mg/L ± 10%.
**
These contaminants are not necessarily in your water supply. Performance may vary based on local water conditions.
® NSF is a registered trademark of NSF International.
Substance
Reduction
Average
Influent
Maximum
Effluent
Average
Effluent
Minimum %
Reduction
Average %
Reduction
NSF Test
Number
Chlorine, Taste/Odor 2.0 mg/L N/A 0.1 mg/L N/A 95% 981788
Contaminant
Reduction
Performance
**
U.S. EPA
MCL
Average
Influent
Maximum
Effluent
Average
Effluent
Minimum%
Reduction
Average%
Reduction
NSF Test
Number
Lead: @ pH 6.5
Lead: @ pH 8.5
0.015 mg/L
0.015 mg/L
0.16 mg/L*
0.14 mg/L*
0.007 mg/L
0.012 mg/L
0.005 mg/L
0.008 mg/L
95%
91%
97%
94%
976115
976116
Substance
Reduction
Average
Influent
Maximum
Effluent
Average
Effluent
Minimum %
Reduction
Average %
Reduction
NSF Test
Number
Chlorine, Taste/Odor 2.0 mg/L N/A 0.1 mg/L N/A 95% 981788
Contaminant
Reduction
Performance
**
U.S. EPA
MCL
Average
Influent
Maximum
Effluent
Average
Effluent
Minimum%
Reduction
Average%
Reduction
NSF Test
Number
Lead: @ pH 6.5
Lead: @ pH 8.5
0.015 mg/L
0.015 mg/L
0.16 mg/L*
0.14 mg/L*
0.007 mg/L
0.012 mg/L
0.005 mg/L
0.008 mg/L
95%
91%
97%
94%
976115
976116
Tested and certified by NSF International against ANSI/NSF
Standard 42 for the reduction of Chlorine (Class I) Taste and Odor
and against ANSI/NSF Standard 53 for the reduction of Lead.
Tested and certified by NSF International against ANSI/NSF
Standard 42 for the reduction of Chlorine (Class I) Taste and Odor
and against ANSI/NSF Standard 53 for the reduction of Lead.
Water Supply
Water Pressure
Water Temperature
City or Well
30 - 120 psi (207 - 827 kPa)
33° - 100°F (0.6° - 37.8° C)