KitchenAid fvsfga Juicer User Manual


 
3
TO USE:
After attaching unit to mixer, place
mixer bowl under strainer tray to catch
strained food and a smaller bowl under
open end to catch food waste. Cut
food into pieces that will fit in the hop-
per. Turn mixer to Speed 4 and feed
food into hopper using stromper.
TO ATTACH:
Before attaching accessory, turn off
and unplug unit.
Loosen attachment knob (1) by turning
it counterclockwise. Remove attach-
ment hub cover. Insert attachment
shaft housing (2) into attachment hub
(3) making certain that attachment
power shaft fits into square hub socket.
Rotate attachment back and forth if
necessary. When attachment is in
proper position, the pin on the attach-
ment will fit into the notch on the hub.
Tighten attachment knob until attach-
ment is completely secured to mixer.
ķĸ
TO ASSEMBLE:
®
A
B
C
D
E
F
G
H
Slide smaller end of spring and shaft assembly (A) into opening in larger worm (B)
until secured firmly in place. Insert the larger worm into the grinder body (C).
Attach strainer cone (D) over the exposed end of the worm matching the tabs of
the cone with the notches in the grinder body. Place ring (E) onto grinder body,
turning by hand until finger tight but not overtightened.
Note: Do not use wrench (F) to tighten ring, only to remove. Slide the strainer tray
(G) over the cone and latch on top of ring. Place splash shield (H) on strainer tray.
2
3
1
Rotating Blade Hazard
Always use food
pusher.
Keep fingers out of
openings.
Keep away from
children.
Failure to do so can
result in cuts or other
injury.
WARNING
!