Filter
Top Products
11
ELECTRONICOVEN CONTROL
First Use/PowerInterruption
When power is first supplied to the range or if power is
interrupted, all indicator lights in the display will appear on for
2 seconds. Then, a buzzer will beep one time and “PF” will
appear in the display window.
Anytime “PF” appears, a power failure has occurred. Turn the
SELECTOR control knob to the RESET position, press the
ENTER button, and follow the clock setting instructions in the
“Clock” section.
Oven SelectorKnob
All cooking functions are set with the SELECTOR knob. Once a
cycle is complete, turn the SELECTOR knob until RESET appears
in the display to select a new function or to turn off the oven.
Cooking functions are:
Bake, Broil, Convect Bake, Convect Roast, Proof, Auto Steam
and Select Steam.
OvenSet Knob
All Auto and Select Steam options, along with all temperature
and time adjustments, are set with the SET knob. All temperature
adjustments are displayed in 5°F (2.8°C) increments.
Auto Steam settings
Meats, Poultry, Fish, Bread and Desserts
Auto Steam settings display temperature and time settings to
guide the cooking process. These may be changed according to
recipe directions.
Select Steam settings
High Steam, Low Steam and Keep Warm
Enter and Cancel
The ENTER button begins any oven function.
The CANCEL button stops any oven function except for the
Clock/Time of Day. After canceling an operation, “StOP” will be
displayed and “Oven On” indicator light will turn off to show the
function was canceled. To exit from the stop mode, turn the
selector knob to RESET.
Once the oven is turned on, a cooling fan will begin to operate
and continue operating until after the oven has been turned off.
This is normal.
Clock
This is a 12-hour clock and does not show a.m. or p.m.
To Set:
1. Turn the SELECTOR knob to the RESET position.
2. Press and hold the ENTER button until the CLOCK indicator
light begins to blink. Release the ENTER button.
3. Turn the SET knob to set the time of day.
4. Press the ENTER button to accept time on display.
To Change: Repeat steps 2-4 to change time of day on the
display.
WaterUsagefor SteamFunctions
Water Level
When you are using the steam functions, the water level indicator
lights will show in the display, indicating the level of the water in
the reservoir.
NOTE: The range must be set to one of the steam functions in
order to fill the system with water.
A.Display
B.Oven selector knob
C.Oven set knob
B
C
A