Filter
Top Products
15
How the Cycle Works
IMPORTANT: The heating and cooling of porcelain on steel in the
oven may result in discoloring, loss of gloss, hairline cracks and
popping sounds.
The High Temp Self-Cleaning Cycle uses very high temperatures,
burning soil to a powdery ash.
The oven is preset for a 4 hour 30 minute clean cycle; however, the
time can be changed. Suggested clean times are 3 hours
30 minutes for light soil and between 4 hours 30 minutes and
5 hours 30 minutes for average to heavy soil.
Use the following chart as a guide to determine the desired
cleaning level.
Once the oven has completely cooled, remove ash with a damp
cloth. To avoid breaking the glass, do not apply a cool damp cloth
to the inner door glass before it has completely cooled.
The oven lights will not work during the High Temp Self-Cleaning
cycle.
On double oven models, only one oven can self-clean at a time. If
one oven is high temp self-cleaning, the other oven cannot be set
or turned on.
NOTE: The oven has a 2 speed cooling fan motor. During self-
clean, the fan(s) will operate at its highest speed to increase airflow
to better exhaust the hotter air through the oven vent(s). An
increase in noise may be noticeable during and after the self-clean
cycle until the oven cools.
To Start High-Temp Self-Cleaning
Before high temp self-cleaning, make sure the door is closed
completely or it will not lock and the cycle will not begin.
1. Touch SELF CLEAN (Upper or Lower Oven). Touch SELF
CLEAN repeatedly to set a clean time other than 4 hours and
30 minutes. The clean time can be set between 3 hours and
30 minutes and 5 hours and 30 minutes.
Number keys cannot be used to set a clean time.
2. Touch START.
The oven will start locking the door and display “Locking Door.”
Opening the door at this point will cancel the self-clean cycle.
“Door Locked” will display once the door is locked. Then, the
start time and stop time will appear in the oven display.
When the cycle is complete and the oven is cool, “self clean
complete” will appear on the oven display and “DOOR
LOCKED” will disappear. The door will not unlock until the
oven is cool.
If enabled, end-of-cycle tones will sound, then reminder tones
will sound every minute.
3. Touch CANCEL for the selected oven, or open and close the
oven door to clear the oven display and/or stop reminder
tones.
To Delay the Start of High Temp Self-Cleaning
Before starting a delayed High Temp Self-Clean cycle, make sure
the clock is set to the correct time of day. See “Clock” section. Also,
make sure the door is closed completely or it will not lock and the
cycle will not begin.
1. Touch SELF CLEAN (Upper or Lower Oven). Touch SELF
CLEAN repeatedly to set a clean time other than 4 hours and
30 minutes. The clean time can be set between 3 hours and
30 minutes and 5 hours and 30 minutes.
Number keys cannot be used to set clean time.
2. Touch STOP TIME.
3. Touch the number keys to enter the time of day to stop.
4. Touch START.
The start time and stop time is automatically calculated and
displayed.
The door will not lock until the start time is reached.
When the start time is reached, the oven will automatically turn
on. The oven will start locking the door and will display
“Locking Door.” Opening the door at this point will cancel the
self-clean cycle. “Door Locked” will display once the door is
locked.
When the cycle is complete and the oven cools, “self clean
complete” will appear on the oven display and “DOOR
LOCKED” will disappear. The door will not unlock until the
oven is cool.
5. Touch CANCEL for the selected oven, or open and close the
oven door to clear the oven display.
To Stop High Temp Self-Cleaning anytime:
Touch Upper or Lower CANCEL. If the oven temperature is too
high, the door will remain locked. It will not unlock until the oven
cools.
General Cleaning
IMPORTANT: Before cleaning, make sure all controls are off and
the oven is cool. Always follow label instructions on cleaning
products.
Soap, water and a soft cloth or sponge are suggested first unless
otherwise noted.
STAINLESS STEEL (on some models)
To avoid damage to stainless steel surfaces, do not use soap-filled
scouring pads, abrasive cleaners, Cooktop Cleaner, steel-wool
pads, gritty washcloths or abrasive paper towels.
Cleaning Method:
Rub in direction of grain to avoid damaging.
■ affresh
®
Stainless Steel Cleaner Part Number W10355016
(not included) or affresh
®
Stainless Steel Cleaning Wipes Part
Number W10355049 (not included):
See “Accessories” section to order.
CLEANING
LEVEL
TOTAL CLEANING TIME
(includes a 30 minute cool down time)
1 (Quick) 3 hours 30 minutes
2 (Reg) 4 hours 30 minutes
3 (Maxi) 5 hours 30 minutes