Filter
Top Products
10
Electronic Control Pads
When pressing any control pad function on the Electronic Oven
Control, use the pad of your finger to press the desired function.
Hold down the pad a few seconds, or until the desired function
appears on the display.
When entering multiple functions within one setting, pause briefly
between each control pad command. If a command pad is
pressed several times repeatedly, the pad may briefly stop
working. Wait a few seconds, and the pad should function again
as normal.
Displays
When power is first supplied to the appliance, everything on the
displays will light up for 5 seconds. Then, “PF” will appear. Press
CANCEL OFF to clear displays.
If “PF” appears at any other time, a power failure has occurred.
Press CANCEL OFF and reset the clock if needed.
Oven Display (on some models)
When the oven is in use, this display shows the oven temperature,
heat source(s) and start time.
During Timed Cooking, this display also shows a vertical bar and
minute time countdown and the stop time (if entered).
If “Err” appears on the display, an invalid pad was pressed.
Press CANCEL OFF and retry your entry.
When the oven is not in use, this display is blank.
Time of Day/Timer Display (on some models)
This display shows the time of day or Timer countdown.
Start
The START pad begins any oven function except the Timer,
Control Lock and Sabbath Mode. If not pressed within 5 seconds
after pressing a pad, “START?” will appear on the oven display as
a reminder. If not pressed within 4 minutes after pressing a pad,
the oven display will return to inactive mode (blank) and the
programmed function will be canceled.
Cancel Off
The CANCEL OFF pad stops any oven function except for the
Clock, Timer and Control Lock.
Clock
This is a 12-hour clock and does not show a.m. or p.m.
To Set:
1. Press CLOCK SET/START.
2. Press number pads to set time of day.
On some models, press the HR and MIN “up” or “down”
arrow pads (buttons) until the correct time shows on the
display.
3. Press START.
To n e s
Tones are audible signals, indicating the following:
One tone
■ Valid pad press
■ Oven is preheated
■ Function has been entered
Three tones
■ Invalid pad press
Four tones
■ End of cycle
■ Reminder, repeating each minute after the end-of-cycle tones
To Enable/Disable Tones:
1. Press CANCEL OFF.
2. Open oven door.
3. Press and hold STOP TIME for 5 seconds.
4. Display will show “SND ON” or “SND OFF.”
Fahrenheit and Celsius
To set oven to cook in Celsius instead of Fahrenheit, open oven
door, then press and hold BROIL for 5 seconds. Repeat to change
back into Fahrenheit.
Timer
The Timer can be set in minutes and seconds or hours and
minutes and counts down the set time.
NOTE: The Timer does not start or stop the oven.
To Set:
1. Press TIMER SET/START.
Press again to switch between MIN/SEC and HR/MIN.
If no action is taken after 4 minutes, the display will return to
the time of day mode.
2. Press the number pads to set length of time.
On some models, press the HR and MIN “up” or “down”
arrow pads (buttons) until the correct time shows on the
display.
3. Press TIMER SET/START.
If not pressed within 4 minutes, the display will return to the
time of day mode and the programmed function will be
canceled.
When the set time ends, if on, end-of-cycle tones will sound,
then reminder tones will sound every minute.
4. Press TIMER CANCEL anytime to cancel the Timer and/or
stop reminder tones.
Remember, if CANCEL OFF is pressed, the oven will turn off.
The time can be reset during the countdown by repeating the
above steps.