Filter
Top Products
Use a magnet to check whether pots or pans are suitable for use on the induction hob: pots are unsuitable
if they cannot be magnetically detected.
- Ensure pots have a smooth bottom, otherwise they may scratch the hob's glass ceramic surface. Check
dishes.
- Never place hot pots or pans on the hob's control panel. This could result in damage.
IMPORTANT: Refer to the "SENSOR" section for correct pan base diameters for cooking zones with
SENSOR function.
Using existing pots and pans
Recommended pan base diameters
OK NO
After unpacking the hob, check that there has been no damage during
transport. If in doubt, contact the dealer or After-Sales Service.
PREPARING THE HOUSING UNIT
- Install a separator panel under the hob.
- The lower part of the product must not be accessible after
installation.
- If there is an oven beneath the hob, do not install the separator
panel.
• For the distance between the underside of the appliance and the
separator panel below, observe the dimensions given in the figure.
• Do not obstruct the minimum required clearance between the hob and
the top of the unit to ensure the correct operation of the product.
• Cut the worktop to fit before installing the hob and carefully remove
any shavings or sawdust.
• If there is an oven beneath the hob, check it has a cooling system.
• For flush-mounting, call the After-Sales Service to fit screw kit 4801 211 00112 supplied with the
product.
• Do not install the hob over a dishwasher or washing machine, as the electronic circuits could become
damaged by steam and humidity.
WARNING
min 5 mm
min 20 mm
min 5 mm
Ø 30 cm
XL
Ø 14 cm
(Dual zone)
➔
30 cm
Ø 28 cm
XL
Ø 18 cm
Ø 14 cm
(Dual zone)
➔
28 cm
Ø 24 cm
L
Ø 17 cm
➔
24 cm
Ø 21 cm
L
Ø 15 cm
➔
21 cm
Ø 18 cm
M
Ø 14 cm
➔
18 cm
Ø 14,5 cm
S
Ø 11 cm
➔
14,5 cm
Installation
8