Filter
Top Products
13
Status Indicators
Control Lock
When Control Lock is lit, all buttons are disabled.
Sanitized
If you select the SANI RINSE™ option, the sanitized indicator
glows when the SANI RINSE™ cycle is finished. If your
dishwasher did not properly sanitize your dishes, the light flashes
at the end of the cycle. This can happen if the cycle is interrupted
or the incoming water temperature is too low. The light goes off
when you open and close the lid.
Check Drain
If the dishwasher senses the drain stopper is not closed properly,
the cycle immediately ends, the lid pops open, and the Check
Drain indicator is lit.
Rinse Aid Empty
Fill the rinse aid dispenser when Rinse Aid Empty is lit. A rinse aid
prevents water from forming droplets that can dry as spots or
streaks. Rinse aid is essential for good drying.
If the rinse aid dispenser is empty, the light glows when you
select a cycle or while a cycle is running.
BRIVA™ In-Sink Wash System
The three-level wash system provides excellent cleaning results.
Three levels of filtration filter the wash water and prevent food
particles from redepositing on the clean dishes.
■
A coarse strainer as part of the drain stopper assembly,
prevents bones, pits, and other large objects from entering
the pump system.
■
Items small enough to pass through the coarse stainer are
caught in the drain screen basket.
■
The wash water continuously flows through the drain fine
screen filter, trapping food particles.
■
Two water jets, located under the spray arm, remove the food
particles from the Drain fine screen filter.
NOTE:
Before each wash load, check the coarse strainer, the
drain screen basket and the fine screen filter and remove any
objects and soil particles. See “Cleaning” for further instructions.
1. Drain stopper assembly with
coarse strainer
2. Drain screen basket
3. Fine filter screen
4. Fine screen filter holder
3
2
1
4