Filter
Top Products
7
INSTALLATION INSTRUCTIONS
Prepare Dishwasher
IMPORTANT: If hot water accessory tank (accessory Part
No. 4396282) will be used, the tank must be installed first.
1. With a utility knife, cut along the back right corner of inner
carton.
2. Remove inner carton. Leave dishwasher on bottom pad.
3. Install faucet (not included). The dishwasher is shipped ready
for installation of a one-hole faucet. If a two-, three- or four-
hole faucet is to be installed, the holes must be added by a
qualified plumber according to the faucet manufacturer's
specifications.
Install Dishwasher
1. Mark countertop and apply a 1/4" (6.4 mm) bead of silicone
caulk 1/4" (6.4 mm) away from dishwasher cutout on sides
and 7/16" (1.1 cm) on front and back.
2. Set the dishwasher into countertop cutout. Make sure front of
dishwasher is parallel to front edge of countertop.
IMPORTANT: To prevent damage to
right-hand hinge, open dishwasher lid
before setting dishwasher into
countertop cutout.
3. Immediately remove any excess caulking.
back of
inner carton
cut along
this corner
1/4" (6.4 mm)
bead of silicone
caulk
dishwasher
cutout
WARNING
Excessive Weight Hazard
Use two or more people to move and install dishwasher.
Failure to do so can result in back or other injury.
4. Install two clamp brackets, evenly spaced, on front, back and
left (sink) side clamp rails. Optional: If space permits, install
two clamp brackets, evenly spaced, on the right side rail.
To install clamps:
■ Hook upper clamp onto rail. Use flat-blade screwdriver to
attach clamp to rail.
■ Use 7/16" deep-well socket and securely tighten nut
against lower clamp. Do not overtighten.
Make Electrical Connection
If you are:
■ direct wiring, use Option 1
■ using a power supply cord, use Option 2
Option 1, Direct wired method
If dishwasher must be directly wired to meet local codes, the
power supply cord must be removed and dishwasher wired
directly. Electrical connections must be contained within the
terminal box and meet all national and local codes and
ordinances.
Route direct wire so that it does not touch lower part of
dishwasher tub to prevent undue sound and vibration.
If power supply cord is removed, the dishwasher must be
connected with copper wire only.
1. Disconnect power.
rail
upper clamp
lower clamp
countertop
WARNING
Electrical Shock Hazard
Disconnect electrical power at the fuse box or circuit
breaker box before installing dishwasher.
Failure to do so can result in death or electrical shock.