Filter
Top Products
5
Back right corner: If countertop is
more than 3/4" (1.9 cm) thick,
measure down 3/4" (1.9 cm) and cut
45° bevel all the way around radius.
19-3/8"
(49.2 cm)
maximum
opened lid
height
20-21/32" (52.5 cm)
9-7/16"
(24.0 cm)
1-3/4" (4.4 cm)
to center of single
hole faucet
factory
installed air
gaps
dishwasher
drain
water inlet
valve
(between clamp rails)
22" (55.9 cm)
(between clamp rails)
5-25/32"
(14.7 cm)
33-11/16" (85.6 cm)
14" (35.6 cm)
18-5/16" (46.5 cm)
22-1/32"
(56.0 cm)
21"
(53.3 cm)
1-1/4"
(3.2 cm)
8"
(20.3 cm)
6-9/16"
(16.6 cm)
center of
sink drain
5-1/2 ft. (1.7 m)
3-prong ground-type
power supply cord
10-7/8" (27.5 cm)
to center of single
hole faucet
A
*NOTE: The cutout must be accurately cut to the dimensions shown within
1/16" (1.6 mm). Dishwasher top flange overlaps the countertop cutout
by 7/16" (1.1 cm) on front and back edges and 1/4" (6.4 mm) on sides.
• Cabinetry and countertop must be sturdy enough to support loaded
dishwasher and sink (400 lbs. [181.4 kg]).
IMPORTANT: Corner radius dimensions
specified must be used. If they are not,
the dishwasher will not fit the opening.
radius: 2-1/4" (5.7 cm)
C
3/4"
(1.9 cm)
45°
for base cabinet
installations, min. 36"
(91.4 cm) width required
21-1/8"
(53.7 cm)
(see *NOTE)
A
A
B
34" (86.4 cm)
(see *NOTE)
A
It is recommended that sink
water and drain line
connections be located on
this side of cabinet.
It is recommended
that dishwasher water
and drain line
connections be
located on this side
of cabinet.
C
21-1/8"
(53.7 cm)
(see *NOTE)
backsplash
CRITICAL
RADIUS
B
radius: 1" (2.5 cm) – the
right back corner must be
cut to this radius
GFCI reset
buttons
25" (63.5 cm) deep
countertop
Countertop must be
level.
SIDE FRONT
34-1/2" (87.6 cm)
7/16" (1.1 cm) min.
flat surface required
KIDS36 Product dimensions
KIDS36 Cabinet requirements