Filter
Top Products
4-14
10. To remove the evaporator:
a) Remove the defrost heater from the
evaporator (see page 4-13).
b) Access the sealed system and dis-
charge the refrigerant into an approved
recovery system.
c) Remove and replace the evaporator.
g) Pull the bottom of the evaporator to-
ward the front of the unit and remove
the two hangers from the defrost heater.
h) Slide the defrost heater off the evapo-
rator.
REASSEMBLY NOTES:
1. The evaporator fan motor shroud has a
foam insert on each side. Note the position
of these inserts in the photo and reinstall
them correctly, as shown.
Foam Inserts
Right Foam Block
Left Styrofoam Block
2. Be sure to reinstall the left styrofoam block
and the right foam block at the locations
shown below.
Defrost Heater Hangers
Evaporator Fan Motor Shroud
Defrost Heater