Filter
Top Products
11
Cycle Selection Charts
Select the wash cycle and options desired. Or press START to
repeat the same cycle and options as the previous cycle.
NOTE:
If the last cycle you completed was a rinse cycle, the
dishwasher will run the last full wash cycle and options that you
selected when you press Start.
■
If the power is off or the door is open for an extended period
of time, the Start button memory will default to the Normal
cycle with heated drying.
■
If you do not run the dishwasher daily, close the door to
maintain memory.
A “
●
” shows what steps are in each cycle.
Temperatures indicate where extra heat is added.
Water usage is shown in
U.S.
gallons/liters.
This model meets the E
NERGY
S
TAR
®
guidelines for energy
efficiency.
Cycle time includes dry time. An asterisk ( * ) by the cycle time
indicates the cycle time might be longer depending on the
temperature of the water entering the dishwasher. The cooler the
water, the longer the cycle time. If the water is already hot
enough, the cycle time will be as shown.
†
A small amount of water is run through the pump to remove
soil particles between the main wash and final rinse.
Canceling a Cycle
Anytime during a cycle, press
Cancel glows. The dishwasher starts a 2-minute drain (if needed).
Let the dishwasher drain completely. The light goes off when the
dishwasher finishes the drain.
To stop the drain
You can press Cancel again to stop the drain immediately.
Remember to drain the dishwasher before starting a new cycle.
To clear the indicators
Press Cancel before starting the dishwasher to clear all options
and cycles.
Changing a Cycle or Setting
During the first minute of a cycle
Press a new cycle and/or options.
After the first minute of a cycle
1.
Press
Cancel glows. The dishwasher starts a 2-minute drain (if
needed). Let the dishwasher drain completely.
2.
Check the detergent dispensers. If the main wash cup has
opened and the detergent washed away, refill the cups as
needed.
3.
Close the door.
4.
Press a new cycle and/or options.
5.
Press START.
Adding Items During a Cycle
You can add an item anytime before the main wash starts. Open
the door and check the detergent dispenser. If the cover is still
closed, you can add items.
To add items
1.
Lift up the door latch to stop the cycle. Wait for the spraying
action to stop before opening the door.
2.
Open the door. If the detergent dispenser cover is still closed,
add the item.
3.
Close the door firmly until it latches. The dishwasher resumes
the cycle after about a 5-second pause.
Use this cycle for
heavily-soiled pots,
pans, casseroles,
regular tableware and
harder than normal
water conditions.
Use both detergent
dispenser sections.
Pre-
Wash
Main
Wash
Rinse Rinse Final
Heated
Rinse
Dry Time
(min)
Water
Usage
(gal/L)
●
130°F
(54°C)
●
140°F
(60°C)
● ●
140°F
(60°C)
●
89* 6.9/26
Use this cycle for loads
with normal amounts of
food soil. (The energy-
usage label is based on
this cycle.)
Use both detergent
dispenser sections.
Pre-
Wash
Main
Wash
Purge† Rinse Final
Heated
Rinse
Dry Time
(min)
Water
Usage
(gal/L)
● ●
120°F
(49°C)
● ●
140°F
(60°C)
●
79* 5.9/22.3
Use this rinse cycle for
rinsing dishes, glasses,
and silverware that will
not be washed right
away.
Do not use detergent
with this cycle.
Pre-
Wash
Rinse Main
Wash
Rinse Final
Heated
Rinse
Dry Time
(min)
Water
Usage
(gal/L)
●
10 1.8/7