Filter
Top Products
17
Drain Air Gap
Check the drain air gap anytime your dishwasher
isn’t draining well
Some state or local plumbing codes require the addition of
a drain air gap between a built-in dishwasher and the
home drain system. If a drain is clogged, the drain air gap
protects your dishwasher from water backing up into it.
The drain air gap is usually located on top of the sink or
countertop near the dishwasher. To order a drain air gap
call your local dealer, or in the U.S.A., call the Consumer
Assistance Center at 1-800-422-1230 and ask for Part
Number 300096.
NOTE: The drain air gap is an external plumbing device
that is not part of your dishwasher. The warranty provided
with your dishwasher does not cover service costs directly
associated with the cleaning or repair of the external drain
air gap.
To clean the drain air gap
Clean the drain air gap periodically to ensure proper
drainage of your dishwasher. Follow the cleaning
instructions provided by the manufacturer. With most
types, you lift off the chrome cover. Unscrew the plastic
cap. Then check for any soil buildup. Clean if necessary.
Storing Your Dishwasher
Storing for the summer
Protect your dishwasher during the summer months by
turning off the water supply and power supply to the
dishwasher.
Moving or winterizing your dishwasher
Protect your dishwasher and home against water damage
due to freezing water lines. If your dishwasher is left in a
seasonal dwelling or could be exposed to near freezing
temperatures, have a qualified person do the following:
1. Disconnect power supply to the dishwasher.
2. Turn off water supply to the dishwasher.
3. Remove the 4 screws on the lower access panel.
Remove the lower access panel.
4. Place a shallow pan under the water supply valve.
Then, use a wrench to disconnect the water inlet from
the water supply valve. Separate the water inlet from
the water supply valve and drain water into the pan.
1. Water outlet
2. Spring clamps
3. Water supply valve
4. Water inlet
5. Water pump and motor
6. Drain hose
5. Remove the spring clamp from the water outlet and
separate from the water supply valve; drain water into
pan.
6. Reconnect both water inlet and water outlet to the
water supply valve.
7. Empty the pan and reposition it under the water pump.
8. Remove the clamp and disconnect the drain hose from
the water pump; drain water into pan.
9. Reconnect drain hose to the water pump, being sure
to position the clamp over the connection.
10.Replace the lower access panel.
NOTE: If your dishwasher is connected to a garbage
disposal, do not run water into the sink after winterizing.
This could cause water to refill the drain hose on your
dishwasher.
Reconnecting your dishwasher
1. Remove the 4 screws on the lower access panel and
remove lower access panel.
2. Turn on the water supply to dishwasher.
3. Turn on power supply to dishwasher.
4. Run dishwasher through a complete cycle and check
for leaks.
5. Replace lower access panel.
1
2
3
4
5
6