14
Status Indicators
Follow the progress of your dishwasher with the Cycle Status
indicators.
Sensing Soak
Your dishwasher senses the soil level on the dishes. Soil level
determines the length of some cycles, the amount of heat or
water added, and the cycle needed for the load. Soaks help
loosen soils on the dishes.
Sensing Soak glows during the sensing and soak parts of the
cycle. Wash action continues while sensing occurs. Wash action
pauses during a soak.
Add a Dish
After a cycle starts, you can add an item to your dishwasher while
Add a Dish glows. After the light turns off, items added to the
dishwasher may not be completely cleaned.
Water Heating
Water Heating glows, and the cycle progression pauses,
whenever water is heated to a set temperature during a cycle.
Wash or rinse action continues as the water heats.
Clean
Clean glows when a cycle is finished. The light turns off when you
open and close the door or press the Cancel pad.
Sanitized
If you select the SANI RINSE™ option, Sanitized glows when the
SANI RINSE™ cycle is finished. If your dishwasher did not
properly sanitize your dishes, the light flashes at the end of the
cycle. This can happen if the cycle is interrupted or the incoming
water temperature is too low. The light goes off when you open
and close the door.
Wash System
The five-level wash system provides excellent cleaning results.
Four levels of filtration, and a soil collector system, filter the wash
water and prevent food particles from redepositing on the clean
dishes.
■
The wash water continuously flows through the Ultra-Fine
filter, trapping food particles.
■
Two water jets, located under the spray arm remove the food
particles from the Ultra-Fine filter.
■
A coarse strainer prevents bones, pits, and other large
objects from entering the pump system.
NOTE:
Periodically check the coarse strainer and remove any
objects on the strainer.
Drying System
During drying, you can see steam escaping through the vent at
the upper left corner of the door. This is normal as the heat dries
your dishes.
IMPORTANT:
The vapor is hot. Do not touch the vent
during drying.
Overfill Protection Float
The overfill protection float (in the front right corner of the
dishwasher tub) keeps the dishwasher from overfilling. It must be
in place for the dishwasher to operate.
Check under the float for objects that may keep the protector
from moving up or down.
WASHING SPECIAL
ITEMS
If you have doubts about washing a particular item, check with
the manufacturer to see if it is dishwasher safe.
Material Dishwasher Safe?/Comments
Aluminum
Yes
High water temperature and detergents
can affect finish of anodized aluminum.
Disposable
Aluminum
No
Do not wash throwaway aluminum pans
in the dishwasher. These might shift
during washing and transfer black marks
to dishes and other items.
Bottles and Cans
No
Wash bottles and cans by hand. Labels
attached with glue can loosen and clog
the spray arms or pump and reduce
washing performance.
Cast Iron
No
Seasoning will be removed and iron will
rust.
China/
Stoneware
Yes
Always check manufacturer’s
recommendations before washing.
Antique, hand-painted, or over-the-glaze
patterns may fade. Gold leaf can discolor
or fade.