KitchenAid KUDS01IL Dishwasher User Manual


 
14
Cycle Selection Charts
Select the wash cycle and options desired. Or press START to
repeat the same cycle and options as the previous cycle.
NOTE:
If the last cycle you completed was a rinse cycle, the
dishwasher will run the last full wash cycle and options that you
selected when you press Start.
If the power is off or the door is open for an extended period
of time, the Start button memory will default to the Normal
cycle with heated drying.
If you do not run the dishwasher daily, close the door to
maintain memory.
A “
” shows what steps are in each cycle.
Temperatures indicate where extra heat is added.
Water usage is shown in
U.S.
gallons/liters.
This model meets the E
NERGY
S
TAR
®
guidelines for energy
efficiency.
Cycle time includes dry time. An asterisk ( * ) by the cycle time
indicates the cycle time might be longer depending on the
temperature of the water entering the dishwasher. The cooler the
water, the longer the cycle time. If the water is already hot
enough, the cycle time will be as shown.
A small amount of water is run through the pump to remove
soil particles between the main wash and final rinse.
NOTES:
The sensor in your dishwasher monitors the soil level. Cycle
time and/or water usage can vary from the numbers above as
the sensor adjusts the cycle for the best wash performance.
In the Normal cycle, the dishwasher pauses while soaking.
Soaking helps loosen soils on dishes for brilliant results.
Use this cycle for hard-
to-clean, baked-on,
cookware and harder than
normal water conditions.
Use both detergent
dispenser
sections.
Soil
Level
Sensed
Pre-
Wash
Main
Wash
Rinse Rinse Final
Heated
Rinse
Dry Time
(min)
Water
Usage
(gal/L)
Heavy
130°F
(54°C)
145°F
(63°C)
160°F
(71°C)
98* 8.8-
10.4/
33-39
Light
130°F
(54°C)
145°F
(63°C)
160°F
(71°C)
91* 6.9/26
Use this cycle for loads with
normal amounts of food
soil. (The energy-usage
label is based on this cycle.)
Use both detergent
dispenser
sections.
Soil
Level
Sensed
Pre-
Wash
Main
Wash
Rinse Rinse
or
Purge†
Final
Heated
Rinse
Dry Time
(min)
Water
Usage
(gal/L)
Heavy
140°F
(60°C)
140°F
(60°C)
94* 7.5-8.8/
28.3-
33.3
Light
120°F
(49°C)
140°F
(60°C)
79* 5.9/
22.3
Use this cycle for china and
crystal. This cycle uses a
light wash and gentle dry.
During the heated dry, the
heating element cycles on
and off.
Use main
detergent
dispenser section.
Soil
Level
Sensed
Rinse Main
Wash
Rinse Purge† Final
Heated
Rinse
Dry Time
(min)
Water
Usage
(gal/L)
Heavy
120°F
(49°C)
135°F
(57°C)
cycled
79* 7.1-8.6/
27-33
Light
120°F
(49°C)
135°F
(57°C)
cycled
71* 5.9/
22.3
Use this cycle for a quick wash
and light dry to cleanup
cookware prior to entertaining.
The sensor adds water and
time to the cycle, if needed, for
maximum cleaning. This cycle
uses a shortened dry time.
Towel drying may be needed.
Use main
detergent
dispenser
section.
Water
Temp
Sensed
Rinse Main
Wash
Rinse Final
Heated
Rinse
Dry Time
(min)
Water
Usage
(gal/L)
Hot
44* 5.2-6.5/
20-25
Cold
48* 7.1-8.2/
27-31
Use this rinse cycle for
rinsing dishes, glasses, and
silverware that will not be
washed right away.
Do not use
detergent with
this cycle.
Soil
Level
Sensed
Pre-
Wash
Rinse Main
Wash
Rinse Final
Heated
Rinse
Dry Time
(min)
Water
Usage
(gal/L)
10 1.8/7