Filter
Top Products
8-2
7. Using only front-to-back motions, clean
the top of the plate, the sidewalls, and the
front edge of the evaporator. The front-to-
back motion is important to prevent
scratches that could keep the ice slab from
sliding off the evaporator plate.
NOTE: More solution may be necessary if
there is a large amount of scale buildup on the
evaporator. The scrubbing process may take
ten minutes or more, depending on the amount
of scale buildup on the plate. The entire plate
should feel smooth when the cleaning is fin-
ished.
8. Pour the remaining solution from the bottle
into the water reservoir. Using the empty
bottle, fill the reservoir with clean water to
within 1/4″ of the top of the overflow port.
Scrub Front-To-Back
Add Remaining Cleaner
5. Read and follow all of the handling infor-
mation that was supplied with the ice ma-
chine cleaner. IMPORTANT: Do not fol-
low the cleaning directions that are printed
on the cleaner bottle. Do not use their
suggested amounts, but use the entire
bottle to clean the unit.
6. Open the bottle and pour a small amount
of cleaning solution onto the cleaning
brush. NOTE: If a brush is not available
you may use a Scotch-Brite
pad.
Cleaning Solution
On Pad
9. Push the Clean keypad. The Clean light
will turn on to show that the Clean cycle is
in progress. When the light turns off (after
approximately 50 minutes), the cleaning
cycle is complete. During the cleaning
cycle, the system both cleans and rinses
itself.
10. After the cleaning cycle is complete, re-
move the drain cap from the water reser-
voir, and see if any cleaning solution is left
in the water as it drains out. If the water is
green in color from the cleaning solution,
it will be necessary to run another cleaning
cycle to flush the system. Be sure to re-
place the drain cap securely to prevent
leaking.
11. When the flushing process is completed,
press the ON keypad to resume ice pro-
duction.