Filter
Top Products
8
For non-vented (recirculating) installation only:
1. Assemble the air deflector with the duct cover bracket using
4 - 4 x 8 mm screws.
2. Measure from the bottom of the air deflector to the bottom of
the hood outlet.
3. Cut the duct to the measured size (X).
4. Remove the air deflector.
5. Slide the duct onto the bottom of the air deflector.
6. Place the assembled air deflector and duct over the exhaust
outlet from the hood.
7. Reassemble the air deflector to the duct cover bracket with
the 4 assembly screws.
8. Seal connections with vent clamps.
Make Electrical Connection
1. Disconnect power.
2. Remove terminal box cover.
3. Remove the knockout in the terminal box cover and install a
UL listed or CSA approved ¹⁄₂"strain relief.
4. Run home power supply cable through strain relief, into
terminal box.
5. Use UL listed wire connectors and connect black wires (C)
together.
A.Assembly screws
B.Air deflector
C.Duct cover bracket
A.Air deflector
B.Vent clamp
C.X = length to cut vent duct
D.Vent duct
E.Exhaust outlet
A
B
C
X
A
C
D
B
E
A.Knockout
B.Terminal box cover
A.Home power supply cable
B.UL listed or CSA approved
strain relief
C.Black wires
D.UL listed wire connectors
E.White wires
F. Green (or bare) and yellow-
green ground wires
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
A
B
A
B
C
D
E
F