Filter
Top Products
16
Classic Series Custom Panels
If you plan to install custom wood panels, you will need to create
the panels yourself or consult a qualified cabinetmaker or
carpenter. See dimension drawings for panel specifications.
IMPORTANT: Panels weighing more than recommended may
cause damage to your refrigerator.
NOTE: Dimensions shown have a (±)¹⁄₁₆" (1.5 mm) tolerance.
Panels that are more than ¹⁄₄" (6.35 mm) thick must be routed. If
panels are less than ¹⁄₄" (6.35 mm) thick, install a filler panel
between the doors and decorative panels.
Top Grille Panel
The top grille panel should not weigh more than 10 lbs (4.5 kg).
NOTE: The dashed lines in the illustration represent the location
and offsets of raised wood panel.
Door Panels for Non-dispenser Models
The freezer panel should not weigh more than 40 lbs (18.1 kg).
The refrigerator panel should not weigh more than 50 lbs (23 kg).
NOTES:
■ If the standard handle is used, the handle side offset of
both panels should be 3¹⁄₄" (8.25 cm) to all for finger
clearance.
■ If an extended handle is used, the handle side offset of
both panels should be ⁷⁄₁₆" (1.1 cm). Make sure the
refrigerator location allows the doors with extended
handles to open to 90 degrees. See “Door Swing
Dimensions.”
■ The dashed lines in the illustration represent the location
and offsets of raised wood panel.
Model A
36
42
48
34¹⁄₄" (87.0 cm)
40¹⁄₄" (102.2 cm)
46¹⁄₄" (117.5 cm)
A
7"
(17.78 cm)
Top & Bottom Offsets
¹¹⁄₁₆" (1.75 cm)
Side Offsets
⁷⁄₁₆" (1.11 cm)
¹⁄₄" thick
plywood
Model A B
36
42
48
14¹⁄₄" (36.2 cm)
16³⁄₄" (42.6 cm)
19¹⁄₄" (48.9 cm)
19¹⁄₄" (48.9 cm)
22³⁄₄" (57.8 cm)
26¹⁄₄" (66.7 cm)
Freezer
Door
(Non-Dispenser)
B
A
Refrigerator
Door
70⁷⁄₁₆"
(178.9 cm)
¹⁄₂"
(1.27 cm)
¹⁄₂"
(1.27 cm)
¹⁄₂"
(1.27 cm)
¹⁄₂"
(1.27 cm)
⁷⁄₁₆"
(1.1 cm)
⁷⁄₁₆"
(1.1 cm)
¹⁄₄" thick
plywood
3¹⁄₄"
(8.3 cm)
Location and offsets
of raised wood panel
3¹⁄₄"
(8.3 cm)
¹⁄₄" thick
plywood