Filter
Top Products
24
OVEN DOOR EXTERIOR
■ Glass cleaner and paper towels or non-abrasive plastic
scrubbing pad:
Apply glass cleaner to soft cloth or sponge, not directly on
panel.
CONTROL PANEL
Do not use abrasive cleaners, steel-wool pads, gritty wash cloths
or some paper towels. Damage may occur.
■ Glass cleaner and soft cloth or sponge:
Apply glass cleaner to soft cloth or sponge, not directly on
panel.
OVEN CAVITY
Do not use oven cleaners.
Food spills should be cleaned when oven cools. At high
temperatures, foods react with porcelain and staining, etching,
pitting or faint white spots can result.
■ Self-Cleaning cycle:
See “Self-Cleaning Cycle” first.
OVEN AND ROASTING RACKS
■ Self-Cleaning cycle:
See “Self-Cleaning Cycle” first. Racks will discolor and
become harder to slide. After cleaning, a light coating of
vegetable oil applied to the rack guides will help them slide.
■ Steel wool pad
BROILER PAN AND GRID
Do not clean in the Self-Cleaning cycle.
■ Mildly abrasive cleanser:
Scrub with wet scouring pad.
■ Solution of ¹₂ cup (125 mL) ammonia to 1 gallon (3.75 L)
water:
Soak for 20 minutes, then scrub with scouring or steel wool
pad.
■ Oven cleaner:
Follow product label instructions.
Porcelain enamel only, not chrome
■ Dishwasher
TEMPERATURE PROBE
■ Plastic scouring pad
Cooktop Light
The cooktop light is located on the top of the control panel. It has
two replaceable parts. The cooktop light is a 20-watt cool-white
fluorescent tube. The starter is a knob-shaped part located on
the right side of the backguard, under the light bulb.
Before replacing, make sure the range is off and cool.
To Replace Light:
1.
Unplug range or disconnect power.
2.
Flip up the top of the control panel.
3.
Grasp both ends of the fluorescent tube.
4.
Turn the tube 90° in either direction until both ends come out
of the receptacles.
5.
Replace tube, replace top of the control panel.
6.
Plug in range or reconnect power.
To Replace Starter:
1.
Unplug range or disconnect power.
2.
Remove tube.
3.
Push starter in and turn approximately 90° counterclockwise.
4.
Pull starter out of recessed area.
5.
Replace starter, tube and top of control panel.
6.
Plug in range or reconnect power.
Resetting Range Circuit Breakers
(on Canadian models only)
The breakers on the range are located under the fluorescent tube
and parallel to the starter. The breakers are for outlet protection.
To reset, push button on top of breakers.