Filter
Top Products
16
Electronic Control Pads
When pressing any control pad function on the Electronic Oven
Control, use the pad of your finger to press the desired function.
Hold down the pad a few seconds, or until the desired function
appears in the display.
When entering multiple functions within one setting, pause briefly
between each control pad command. If a command pad is
pressed several times repeatedly, the pad may briefly stop
working. Wait a few seconds, and the pad should function again
as normal.
Oven Displays
When the oven is in use, this display shows the oven
temperature, heat source(s) and start time. During Timed
Cooking, this display also shows a timed countdown and the
stop time (if entered).
If “Err” appears on the display, an invalid pad was pressed.
Press OFF and retry your entry. When the oven is not in use, this
display is blank.
Start
The START pad begins any oven function except the Timer,
Control Lock and Sabbath Mode. If not pressed within 5 seconds
after pressing a pad, “START?” will appear on the oven display as
a reminder. If not pressed within 5 minutes after pressing a pad,
the oven display will return to inactive mode (blank) and the
programmed function will be canceled.
If a function has been started and a different function is selected,
“START?” will appear in the display after 5 seconds. If the START
pad is not pressed within 5 seconds, the oven display will return
to the active/already started function.
Control Lock
The Control Lock feature shuts down the control panel pads to
avoid unintended use of the oven.
The Control Lock feature may be used either when the range is in
use or turned off (for example, during cleaning).
The Control Lock is preset unlocked, but can be locked.
When the control is locked, only the TIMER SET/START, TIMER
OFF and OVEN LIGHT pads will function.
To Lock/Unlock Control: Before locking, make sure the oven,
the Timer and Timed Cooking are off. Press and hold the START
pad for 5 seconds until “CONTROL LOCK” appears on the
display. Repeat to unlock and remove “CONTROL LOCK” from
the display.
Off
The OFF pad stops any oven function except for the Warming
Drawer, Clock, Timer and Control Lock.
Clock/Timer Display
This is a 12-hour clock.
1. Press CLOCK SET/START.
2. Press number pads to set time of day.
3. Press CLOCK SET/START
Timer
The Timer can be set in minutes and seconds or hours and
minutes and counts down the set time.
NOTE: The Timer does not start or stop the oven.
1. Press TIMER SET/START.
Press again to switch from MIN/SEC and HR/MIN.
2. Press the number pads to set length of time.
3. Press TIMER SET/START to start the timer.
When the set time ends, timer completion tones will sound,
then reminder tones will sound approximately every
10 seconds.
4. Press TIMER OFF anytime to cancel the Timer and/or stop
reminder tones.
If OFF is pressed, the oven will turn off.
The time can be reset during the countdown by repeating the
above steps.
OPTIONS
Options Selection Pad
The OPTIONS selection pad allows you to access special
functions within the Electronic Oven Control that allow you to
customize the product to your needs. These special functions
allow you to change the oven temperature between Fahrenheit
and Celsius, turn the audible signals and prompts on and off, and
adjust the oven calibration. The Dehydrate and Sabbath Mode
are also set using the OPTIONS selection pad.
To Use:
Press OPTIONS. The oven display will scroll through the various
options, starting at 1 and ending in 7. You can also press the
OPTIONS selection pad and number pad to quickly enter the
desired hidden function.
*Available only on convection models.
Fahrenheit and Celsius - Option 1
Fahrenheit is the default setting, but setting may be changed to
Celsius.
To Change: Press OPTIONS, then 1 on the keypad for Celsius.
To convert back to Fahrenheit, press OPTIONS, then 1 again on
the keypad.
OPTIONS SPECIAL FUNCTION
1 Fahrenheit and Celsius conversion
2Tones On/Off
3 Tones High/Low
4 Cooking Time Completion Tones On/Off
5* Dehydrate
6 Oven temperature calibration
7 Sabbath Mode