KitchenAid YKESC308 Range User Manual


 
10
Electronic Control Pads
When pressing any control pad function on the Electronic Oven
Control, use the pad of your index finger to press the desired
function. Hold down the pad a few seconds, or until the desired
function appears in the display.
When entering multiple functions within one setting, pause briefly
between each control pad command. If a command pad is
pressed several times repeatedly, the pad may briefly stop
working. Wait a few seconds, and the pad should function again
as normal.
Displays
When power is first supplied to the appliance, everything on the
displays will light up for 5 seconds. Then, PF will appear. Press
CANCEL OFF to clear displays.
If PF appears are any other time, a power failure has occurred.
Press CANCEL OFF and reset the clock if needed.
Oven Display (on some models)
When the oven is in use, this display shows the oven temperature,
heat source(s) and start time.
During Timed Cooking, this display also shows a vertical bar and
minute time countdown and the stop time (if entered).
If Err appears on the display, an invalid pad was pressed.
Press CANCEL OFF and retry your entry.
When the oven is not in use, this display is blank.
Time of Day/Timer Display (on some models)
This display shows the time of day or Timer countdown.
Start
The START pad begins any oven function except the Timer,
Control Lock and Sabbath Mode. If not pressed within 5 seconds
after pressing a pad, START? will appear on the oven display as
a reminder. If not pressed within 4 minutes after pressing a pad,
the oven display will return to inactive mode (blank) and the
programmed function will be canceled.
Cancel Off
The CANCEL OFF pad stops any oven function except for the
Clock, Timer and Control Lock.
Clock
This is a 12-hour clock and does not show a.m. or p.m.
To Set:
1.
Press CLOCK SET/START.
2.
Press number pads to set time of day.
On some models, press the HR and MIN up or down
arrow pads (buttons) until the correct time shows on the
display.
3.
Press START.
To n e s
Tones are audible signals, indicating the following:
One tone
Valid pad press
Oven is preheated
Function has been entered
Three tones
Invalid pad press
Four tones
End of cycle
Reminder, repeating each minute after the end-of-cycle tones
To Enable/Disable Tones:
1.
Press CANCEL OFF.
2.
Open oven door.
3.
Press and hold STOP TIME for 6 seconds.
4.
Display will show SND ON or SND OFF.
1. Oven Display Symbol
2. Heat Settings
3. Oven Display
4. Start/Stop Time
5. Number Pads
6. Control Lock (on some models)
7. Start
8. Oven Settings
9. Clock
10. Minute Timer
11. Timed Cooking
12. Surface Light
(Control Lock on some models)
13. Oven Light
14. Cancel Off