Filter
Top Products
5
Preparation before Installation
NOTE: TO AVOID DAMAGE TO YOUR HOOD,
PREVENT DEBRIS FROM
ENTERING THE VENT OPENING.
Decide the location of the venting pipe
from the hood to the outside. Refer to
Figure 1.
A straight, short venting run will allow
the hood to perform more efficiently.
Try to avoid as many transitions,
elbows, and long run as possible. This
may reduce the performance of the
hood.
Temporarily wire the hood to test for
proper operation before installing.
Peel protective film off the hood (if any).
Make sure the cabinet has full access
opening for the hood as shown on
Figure 2.
Hood Installation
CAUTION: If required to move the cooking
range to install the hood, turn off the power
on an electric range at the main electrical
box. SHUT OFF THE GAS BEFORE MOVING
A GAS RANGE.
1. Using references on Table 1 and
measurements on page 11 mark the
leveling point for hood-mounting bracket
inside the cabinet.
2. Secure two hood mounting screws (not
provided) inside the cabinet leaving 1/8”
away from the cabinet as shown on Figure
3.
3. Loosen hood-mounting brackets at the
back of the hood, adjust brackets and
tighten screws as shown in Figure 4.
4. Refer to Figure 5. Align hood-mounting
bracket to the mounting screws inside the
cabinet and hook hood into place. Secure
and tighten the mounting screws.
CAUTION: MAKE SURE THE HOOD IS
SECURE BEFORE RELEASING.
Figure 1
Figure 2
Figure 3
Figure 4