Kompernass KH498-03 Blender User Manual


 
- 4 -
Assembling the liquidiser
Warning:
The blade is extremely sharp.
Handle it with great care. Risk of injury!
Place the blade
6
carefully on its retainer
in the bowl
7
.
Fill the bowl with the foodstuffs you wish to
liquidise.
Place the lid
5
over the vessel and turn it until
tight. Ensure that the lid lugs are guided into
the grooves of the vessel on the edge.
Place the motor unit
3
on the lid
5
, ensuring
that it clicks in audibly.
Note:
The arrows on the motor unit and the accessory
must stand one above the other .
Operation
Warning:
Foodstuffs should not be too hot.
Squirted-out contents may cause scalding.
Fire Danger:
Never exceed the maximum operating duration of
1 minute for soft foodstuffs, respectively,15 seconds
for solid foodstuffs. Allow the appliance to cool
down for 2 minutes before switching it on again.
When you have assembled the hand blender for
your particular purpose, place ...
the plug in the mains socket.
Hold down the switch
1
to process the
foodstuffs at the standard speed.
Hold down the turbo-switch
2
to process
the foodstuffs at the higher speed.
When you have completed processing
the foodstuffs, simply release the switch.
Wall mounting
Included are 2 plugs and 2 screws to enable the
wall bracket
w
to be assembled. We recommend
mounting the appliance close to a power point
Mark the position of drill holes using the
appliance holder
w
.
Bore the holes with a 6 mm drill.
Insert the dowels into the drill holes.
Position the openings of the wall bracket
over the bored holes, then fix it using
both screws.
Cleaning
Danger of electrical shock!
Before you clean the hand blender, unplug the
appliance from the power socket. Under no circum-
stances may the motor unit
3
be cleaned by immer-
sing it in water or holding it under running water.
Danger of injuries!
To prevent injuries, exercise caution when handling
the extremely sharp blade
6
. Reassemble the liqui-
diser after use and cleaning to prevent injuries from
exposed knife blades. Keep the blade out of the
reach of children.
Attention!
The attachments of the hand blender may not
be cleaned in a dishwashing machine, this would
damage them.
Unplug the power cord from the wall socket.
Clean the motor unit
3
, the handblender
4
,
the lid
5
and the whisk holder
8
with a well
squeezed out sponge.
Ensure that no water can enter the openings
of
4
the hand mixer.
Clean the rest of the attachment components
under running water and dry them off well
with a dish-towel.
IB_KH498_E3339_GB_LB3-6 05.03.2008 12:28 Uhr Seite 4