Filter
Top Products
- 6 -
Warning:
To avoid blockage of the juice outlet and/or damage
to the appliance, regularly clean the juice outlet
and juice container, and always after every usage.
Emptying the pulp container
and the filter
You can extract juices continuously until the container
for fruit pulp and vegetable mash
s
is completely
full.
Warning:
Remove the plug from the power source when
emptying the filter
d
.
When the extracted juices suddenly become thicker,
or when you hear that the motor is running slower,
the filter
d
must be emptied. When you have removed
the fruit pulp/vegetable mash, reassemble the
appliance.
Disassembly of the juice extractor
If you wish to disassemble the juice extractor, e.g.
to clean it, proceed as follows:
1. Remove the power plug from the wall socket
i
.
2. Open the clasps
r
.
3. Remove the housing lid
e
with the stodger
q
.
4. Carefully lift up the juice container
t
. With this,
the filter
d
releases itself from the drive shaft
f
.
You can now take the filter
d
out of the juice con-
tainer
t
.
Cleaning and Care
Warning:
ALWAYS remove the power plug from the wall socket
before removing or installing accessories and before
cleaning the appliance. To avoid blockage of the
juice outlet and/or damage to the appliance, all
appliance and ancillary parts must be regularly,
and after every use, cleaned free of fruit pulp and
vegetable mash.
• Switch the appliance off at the On/Off switch
o
.
• Soiling or overflowing fruit juices should be cleared
away immediately, as fruit stains are difficult to
remove later.
• For cleaning the appliance housing and the power
cable, use a cloth that is only lightly moistened.
• Clean the stodger
q
, housing lid
e
and container
for fruit pulp and vegetable mash
s
in warm
soapy water and then carefully rinse them off.
The stodger
q
, housing lid
e
and container for fru-
it pulp and vegetable mash
s
are suitable for clea-
ning in a dishwasher and can be cleaned there. To
clean the filter
d
, use the supplied nylon brush:
• Turn the lid of the stodger
q
until the arrow points
to the opened lock on the stodger shaft. You
can now remove it. The nylon brush is inside the
stodger
q
. To re-close the lid, place it on the
stodger so that the arrow points to the opened
lock .
Then turn it until the arrow points at the closed
lock . The lid now sits firmly.
• Hold the filter
d
(with the underside upwards)
under running water and clean it with the nylon
brush.
IB_KH451_E2249_LB6.qxd 15.02.2008 13:09 Uhr Seite 6