Filter
Top Products
- 6 -
Should this not dislodge the soiling, you can separate
the lower plastic part of the mixer jug
e
(with the cut-
ters
r
) from the the glass part:
➩
Remove the mixer jug
e
from the motor block
u
.
➩
Turn the plastic element ả of the mixer attach-
ment
e
anti-clockwise, such that it allows itself to
be released from the glass element Ạ.
ƽ
Attention!
Take care with the cutters Ả. They are very sharp.
Risk of injury!
➩
Clean both parts thoroughly in a mild soapy
solution or in a dishwasher.
➩
Replace the plastic part ả of the mixer jug
e
back onto the glass part Ạ. Ensure that the sea-
ling ring ạ is correctly fitted.
ạ
ả
Ạ
Ả
Cleaning the motor block
➩
Use a dry cloth or, at the most, a lightly moistened
one for cleaning the plastic surfaces.
➩
At every cleaning check that the contact switch
in the receptor for the mixer jug
e
is not blok-
ked by soiling residues. If you cannot dislodge
any blockages with the corner of a piece of pa-
per, make contact with Customer Services. Un-
der no circumstances should you use a hard ob-
ject, this could damage the contact switch.
➩
Remove any possible residues on the underside
of the motor block
u
only with a dry cloth or a
stiff bristled brush. Ensure that nothing can enter
through the ventilation opening of the appliance.
After cleaning
Allow all parts to dry well before re-assembling and
re-using the liquidiser.
Storage
➩
If you do not intend to use the liquidiser for an
extended period, clean it thoroughly (see chapter
"Cleaning").
➩
Wrap the power cable
y
around the cable sto-
rage
i
on the base of the motor block
u
.
➩
Store the liquidiser at a cool and dry location.
IB_KH528_46300_LB6 07.01.2010 10:09 Uhr Seite 6