Koolatron 12 Volt DC 10 Cup Coffee Maker Coffeemaker User Manual


 
Running off your vehicle’s cigarette lighter socket or 12-Volt DC power port, the
Coffee Maker will brew and keep up to 10 cups of coffee piping hot. The unit comes
complete with a unique drip-stop filter holder.
Please read this manual carefully before operating your coffee maker and store in a
safe place for future reference.
Important Warning
Operate only when your vehicle’s motor is running to avoid draining the battery.
Make sure to place the unit on a flat, heat-resistant surface.
Keep the power cord well away from the unit’s hot plate.
Keep the unit well away from flammable materials.
Do not use near, or immerse the unit in water.
Keep out of reach of children.
Always unplug the unit after use.
Only use 12 Volt DC current to power the unit.
Make sure that the unit is cool before cleaning.
The unit should not be left unattended when in use.
Never operate the unit when the vehicle is in motion.
Always empty the glass carafe before operating the vehicle.
Never use harsh or abrasive cleaning agents to clean the unit.
Operation of the unit when it is empty may cause a fire hazard.
Never use the unit for any other purpose other than which it was intended.
Never use accessories or attachments not recommended by the manufacturer.
Do not place the glass carafe in a microwave oven, on an open flame, or open
hotplate.
Do not open the Coffee Maker. There are no other serviceable parts in this product
doing so will void the warranty.
Operating Instructions
Remove the glass carafe, and fill with the desired amount of water.
Open hinged lid and pour the water into the water reservoir.
Insert filter into filter holder, and add the desired amount of coffee grounds.
Close the hinged lid and glass carafe lid and place the carafe on the hotplate.
Connect the unit to your vehicle’s cigarette lighter socket or 12 Volt Power socket.
Turn unit ON by pressing the ON/OFF button (The button will illuminate to show the
unit is operating).
Brewing will begin shortly after the unit is turned ON.
Wait for carafe to fill up with freshly brewed coffee.
Location of Controls
1) Drip-stop filter holder.
2) Lid for tempered glass carafe
3) Tempered glass carafe
4) Hot Plate
5) Illuminated On/Off button
6) Water Reservoir
7) Hinged lid
Cleaning and Care
Unplug unit and leave to cool down.
Open the hinged lid, and remove the drip-stop filter holder by tuning it
counterclockwise.
(To replace the filter holder, turn it clockwise until it ‘clicks’ into place).
Remove the filter and throw away the used coffee grounds (and paper filter).
Clean the carafe, carafe lid and filter holder in a dishwasher or with hot water and a
mild soap.
Wipe the inside of the water tank clean with a damp cloth.
Note: Allow unit to cool for at least 3 minutes before brewing coffee again.