Filter
Top Products
Using the SDI-AES De-Embedder / SDI-AES Embedder
5
5.1 Connecting the 6808 SDI-AES De-Embedder
To connect the 6808 SDI-AES De-Embedder, as the example in Figure 3
illustrates, do the following
1
:
1. Connect an SDI source (for example, a digital video player) to the SDI IN
BNC connector.
2. Connect the SDI LOOP BNC connector (OPTIONAL) to the SDI IN
BNC connector on an additional unit to increase outputs (see Figure 7).
3. Connect the AES OUTPUT A BNC connector
2
(for channels 1-2) to a
digital audio acceptor for channels 1 and 2 (for example, DAT-Recorder A)
4. Connect the AES OUTPUT B BNC connector
2
(for channels 3-4) to a
digital audio acceptor for channels 3 and 4 (for example, DAT-Recorder B)
5. Set the GROUP SELECT dipswitches to choose the audio group (see
section 5.2.1).
6. Connect the 12V DC power adapter to the power socket and connect the
adapter to the mains electricity.
Figure 3: Connecting a 6808 SDI-AES De-Embedder
1 Switch OFF the power on each device before connecting it to your 6808. After connecting your 6808, switch on its power
and then switch on the power on each device. Switching on the 6808, recalls the last status prior to powering down
2 When only one digital audio stream containing 2 audio channels is required, use either of the AES outputs, and leave the
other AES output unconnected