Kramer Electronics WP-306 Ventilation Hood User Manual


  Open as PDF
of 2
 
The Kramer WP-306 Wall Plate
Congratulations on purchasing your Kramer WP-306 Wall Plate which is ideal for
boardrooms and presentation rooms.
The WP-306 is a single-gang wall plate insert.
WP-306 Wall Plate US Version
Figure 1 and Table 1 define the US version of the WP-306 Wall Plate.
Figure 1: WP-306 Wall Plate US Version Front and Rear View
Table 1: WP-306 Wall Plate US Version Front and Rear Features
# Feature Function
1 ON LED Lights red when receiving power (when no signal is detected); lights
green when receiving a signal
2 HDMI IN Connector Connect to the HDMI digital source
3 IR OUT 3.5mm Mini Connector Connect to a machine via an IR Emitter. Note, that the IR output is
only compatible with the SV-552
4 RJ-45 Connector Connect to the SV-552 Processor/Controller. Note that the WP-306
requires BC-DGKat524 or BC-DGKat-623 cable for connection
5 DC IN Power Connector Connect to the 12V power supply (supplied free)
Wiring the Twisted Pair RJ-45 Connector
The US versions of the wall plates are equipped with RJ-45 terminals. Figure 2 defines the
STP pinout using a straight pin to pin cable with RJ-45 connectors. For STP cable, cable
shielding must be connected/soldered to the connector shield.
Note: For cabling WP-306 wall plates, use either Kramer BCP-DGKat524 or
BCP-DGKat623 STP cables.
EIA /TIA 568B
PIN Wire Color
1 Orange/White
2 Orange
3 Green/White
4 Blue
5 Blue/White
6 Green
7 Brown/White
8 Brown
Pair 1 4 and 5
Pair 2 1 and 2
Pair 3 3 and 6
Pair 4 7 and 8
Figure 2: RJ-45 Pinout (U.S.)
WP-306 Wall Plate EU/UK Versions
Figure 3 and Table 2 define the EU/UK version of the WP-306 Wall Plate.
Destination Belgium and Germany
Destination England and the rest
of Europe (excluding Belgium and
Germany)
Rear panel view
Figure 3: WP-306 Wall Plate EU/UK Version Front and Rear Views
Table 2: WP-306 Wall Plate EU/UK Version Front and Rear Features
# Feature Function
1 ON LED Lights red when receiving power (when no signal is
detected); lights green when receiving a signal
2 HDMI IN Connector Connect to the HDMI digital source
3 IR OUT 3.5mm Mini Connector Connect to a machine via an IR Emitter. Note, that the IR
output is only compatible with the SV-552
4 Terminal Block
Connect to SV-552. Note that the WP-306 requires
BC-DGKat524 or BC-DGKat-623 cable for connection
5 GROUND Connection Ring tongue terminal and grounding screw
6 GND +12V 2-pin Power Terminal Block Connect to the 12V power supply (included)