Filter
Top Products
Instructions for assembly
GB
31
Electrical connection
• Statutory regulations and the connection specifications issued
by the local power supply company must be strictly observed.
• Any superfluous cable must be removed from the installation
area beneath the appliance.
• Make sure that the local mains voltage is the same as the volt-
age on the rating label.
• The induction hob has been fitted with a connection cable in
the factory.
• The appliance is supplied ready to plug in. It should be con-
nected only to a properly protected wall socket.
• If damaged, the Customer Service must replace the connec-
tion cable installed with a special connection cable.
• The wall-socket can be mounted under the working top below
the hob or in a side cupboard in the wall. Do not mount it
above the cooking area!
• Full protection against accidental contact must be ensured on
installation.
Power supply
Mains voltage: 220 - 240V~, 50-60 Hz
Component rated voltage: 230 - 240V
Technical data
Start of operation
Once the hob has been installed and the power supply has been
provided (mains connected) an automatic test of the controls will
be carried out and information for Customer Service will be indi-
cated.
Important: No items may be on the touch control sensor keys
when the appliance is being connected!
Briefly wipe over the surface of the hob with a sponge and soapy
water and then dry with a clean cloth.
Hob dimensions
Height/ Width/ Depth . . . . . . . mm 50 x 450 x 519
Cooking zones
front . . . . . . . . . . . . . . .Ø cm / kW
rear . . . . . . . . . . . . . . .Ø cm / kW
16/ 1,4
25/ 2,3
Hob
total . . . . . . . . . . . . . . . . kW 3,7