Lennox Hearth TK3-33BS Appliance Trim Kit User Manual


 
Printed in U.S.A Lennox Hearth Products 2004
P/N 775,175M REV. B, 12/2005 Page 2 of 2 1110 West Taft Avenue Orange, CA 92865
LENNOX reserves the right to make changes at any time, without notice, in design, materials,
specifications, prices and also to discontinued colors, styles and products.
Consult your local distributor for fireplace code information
.
Completed Trim Panel Installation
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
Step 4. Install the side trim panels onto each side of fireplace face as
follows:
Brass and Stainless Trim Kits – Place side trim over channels,
then press firmly so double sided tape adheres panels to chan-
nels (see Figure 5 ).
Black Trim Kits – Place side trim panels over magnets on each
side of the fireplace face as shown in Figure 5.
Note: Magnets were installed on Step 1, Figure 2.
Step 5.
Brass and Stainless Trim Kits - Peel off the backing on double-
sided tape on the backside of the top trim panel. Press fit the top
channel against the top trim panel as shown in Figure 6.
Black Trim Kits – Proceed to Step 6.
Step 6. Place 2 magnets on the backside of the top trim panel as shown in
Figure 6.
Step 7. Place the Top Trim Panel over the Side Trim Panels as shown
in Figure 7.
Brass and Stainless Trim Kits – The metal channel should
go behind the side trim panels. Squeeze top and side trim
pieces together.
Black Trim Kits The magnets act as support to hold the
trim panel in place.
Figure 4
Backing
Double
Sided
Tape
Figure 5
Backside of Side
Trim Panel
Figure 7
Right Side
Trim P
a
n
e
l
Magnet
Backside of Top
Trim Panel
Black Trim kits do not include channels or doubl
e
-
sided
ta
p
e. See Note on
p
a
g
e 1.
Top Channel
Figure 6
Double-sided Tape
~ 3”
Typical