Filter
Top Products
5
ENGLISH
I N S TA L L AT I O N I N S T RU C T I O N S
READ ALL INSTRUCTIONS BEFORE INSTALLATION
TOOLS YOU WILL NEED MATERIALS YOU MAY NEED
• Gas line shut-off valve
• Pipe joint sealant that resists action of natural and LP gases.
• Flexible metal appliance connector (3/4” or 1/2” NPT x 1/2”
I.D.)
Never use an old connector when installing a new range.
• Flare union adapter for connection to gas supply line (3/4” or
1/2” NPT x 1/2” I.D.)
• Flare union adapter for connection to pressure regulator on
range (1/2” NPT x 1/2” I.D.)
• Liquid leak detector or soapy water.
• Lag bolt or 1/2” O.D. sleeve anchor (for concrete floors only).
PREPARING FOR INSTALLATION
• This product must be installed by a licensed plumber or
gas fitter.
• When using ball type gas shut-off valves, they shall be
the T-handle type.
• When using a flexible gas connector, it must not exceed
3 feet in length.
IN THE COMMONWEALTH OF MASSACHUSETTS
Phillips screwdriver
Flat-blade screwdriver
Pencil and ruler
Pipe wrench(2)
(one for support)
Open-end or
adjustable wrench
Level
• If a 30” clearance between cooking surface and
overhead combustible material or metal cabinets
cannot be maintained, protect the underside of
the cabinets above the cooktop with not less than
1/4” insulating millboard covered with sheet metal
not less than 0.0122” thick. Clearance between
the cooking surface and protected cabinets MUST
NEVER BE LESS THAN 24 INCHES.
• The vertical distance from the plane of the cooking
surface to the bottom of adjacent overhead
cabinets extending closer than 1” to the plane of
the range sides must not be less than 18”. (See
the Dimensions and Clearances illustration in this
manual.)
• Items of interest to children should not be stored
in cabinets above a range or on the backsplash of
a range—children climbing on the range to reach
items could be seriously injured.
• DO NOT attempt to operate the oven of this range
during a power failure.
WARNING!
INSTALLATION SAFETY INSTRUCTIONS (continued)
CAUTION