Filter
Top Products
CRISPER COVER WITH LATTICE ON INNER
SURFACE (on some models)
To remove the crisper cover:
1. Remove both crisper drawers.
2. While holding the crisper cover support (2), pull the
cover up and out(1).
WARNING: Be careful when handing glass cover since
glass is not attached to cover.
To remove the lattice on inner surface:
1. Remove crisper cover(as illustrated above).
2. Hold the glass cover and overtum crisper cover.
3. For each lattice hold lattice and pull sides of the cover
outward to remove lattice.
To replace lattice on inner surface:
1. For each lattice insert middle tab in 1 (closed to glass
cover)and pull sides of the cover to insert lattice.
DOOR RACKS
The door racks may be removed for easier cleaning.
Snap-on Door Racks
To remove the racks:
1. Remove all items in the door racks.
2. Push the rack against the inside wall of the door (A)
and lift up the door rack (B).
To replace the racks:
1.
Hold either end of the door rack against the inside wall of the door.
2. Push down the rack until it locks in place.
DESIGN-A-DOOR
1. Bins can be moved to either side of the door.
2.
To remove the bin, simply lift the bin and pull straight out.
3. To replace the bin, slide it in above the desired
support and push down until it locks completely
so that
“click” sounds can be heard.
4. To move to lowest position, make sure if all bins are
correctly assembled so that they don’t fall out of door.
Warning: Somebody can be hurt if door bins are not
firmly assembled.
NOTE: Do not adjust a bin that is loaded with food.
USING YOUR REFRIGERATOR
24
USING YOUR REFRIGERATOR
!
!