OO
PPEERRAATTIINNGG SSEEQQUUEENNCCEE
16
OPERATING SEQUENCE
1. Press the power button.
Press the power button to see the default
setting.
2. Check rinse-aid level and
open the door.
The indicator lights will illuminate if refilling
is necessary.
3. Load the dishes after first
removing any scraps of food.
Remove any scraps of food in advance.
Pull the lower rack out and load the dishes
and cutlery in and push it all the way back.
Pull the upper rack out and load the cups,
glasses, etc.
4. Ensure that the spray arms
can rotate freely.
5. Measure detergent.
Add the required amount of detergent into
the dispenser. Close the detergent
dispenser lid.
6. Setting the program.
Select desired program and options. Before
starting, the display window will show the
estimated running time of the selected
program. If the number of dishes only fill
one rack, you can use the Half Load option.
For example, if you load dishes only on the
upper rack, you adjust the half load button
to the upper rack.
Remember to load all dishes into the
selected rack.
The estimated remaining time will be
displayed. If the door is opened during
operation, the dishwasher stops. Once the
door is closed, the program will restart from
the point where it's stopped.
7.
Close the door. The dishwasher
will start automatically.
8. At the end of the Program.
End is displayed on the digital display for a
few seconds and a tone will sound
signaling the program completion. The
dishwasher automatically switches off for
safety and energy savings.
Caution
Empty the lower rack first and then the
upper one, this will avoid water dripping from
the upper rack onto the dishes in the lower
one.
Warning
In general, it is not advisable to open the
door while the dishwasher is running. If the
door is opened, a safety device stops the
machine. Care should be taken when
opening the door immediately following the
cycle, as steam may escape.
Auto-Off
When the power is turned on, if you don’t
select a program or if you don’t close the
door after selecting a program, your
dishwasher will automatically turn off in 10
minutes.