Filter
Top Products
14
U
SING YOUR DISHWASHER
When the lamp is on, it indicates
the rinse-aid reservoir is almost empty.
2. Add a liquid rinse aid to the maximum level.
(Max. 4.8 oz (145mL))
3.Replace and lock the cap.
4. Rinse aid will be automatically dispensed during
the final rinse cycle.
�Rinse Aid Amount Setting
The factory setting is at level 3 which is where you
can expect the best performance under a normal
condition. After a cycle is done, if you notice some
spots, streaks or water marks on the dishes, adjust
to a higher setting. If you notice foam present on the
bottom of the glasses or tub bottom, change to a
lower setting.
1. Remove the cap.
2. Rotate adjuster to the desired setting.
��
Refilling Rinse Aid
4.8 oz (145mL) is the capacity of the rinse aid
dispenser. The refilling period totally depends on
your washing habits such as the number of washes
per month and which rinse aid setting you adjust to
your washing conditions. The indicator light will
inform you when there is insufficient rinse aid in the
dispenser. The indicator light will stay on when you
close the door to start a cycle.
��
Black indicates sufficient Rinse Aid
��
Clear indicates Rinse Aid required
USING YOUR DISHWASHER
Adding Rinse Aid to dispenser
The purpose of rinse aids is to prevent possible
spots on dishes formed from droplets during drying
operation. By removing them, drying performance
will be increased.
NOTE
Only liquid rinse aids can be used for this dishwasher.
�Filling Rinse Aid
1. Rotate the round cap counterclockwise and
remove it.
3828DD3002Q(영어) 2005.1.20 12:57 PM 페이지14 001 HP LaserJet 5000 Series