Filter
Top Products
24INSTALLATION
Turning On The Power
1
Plug in the refrigerator.
Leveling and Door Alignment
Leveling
After installing, plug the refrigerator’s power
cord into a 3-prong grounded outlet and push
the refrigerator into the nal position.
Your refrigerator has two front leveling legs—
one on the right and one on the left. Adjust the
legs to alter the tilt from front-to-back or side-to-
side. If your refrigerator seems unsteady, or you
want the doors to close more easily, adjust the
refrigerator’s tilt using the instructions below:
1
Turn the leveling leg to the left to raise
that side of the refrigerator or to the right
to lower it. It may take several turns of
the leveling leg to adjust the tilt of the
refrigerator.
2
Open both doors again and check to make
sure that they close easily. If the doors do
not close easily, tilt the refrigerator slightly
more to the rear by turning both leveling
legs to the left. It may take several more
turns, and you should turn both
leveling legs
the same amount.
CAUTION
Connect to a rated power outlet.
Have a certied electrician check
the wall outlet and wiring for proper
grounding.
Do not damage or cut o the ground
terminal of the power plug.
NOTE
A are nut wrench works best, but an open-
end wrench will suce. Do not over-tighten.
ENGLISH