Filter
Top Products
- 15 -
You will need two people to lift this
microwave. Failure to use more
than one person could result in
personal injury.
1. Carefully lift microwave oven and hang it on
support tabs (See Figure 24, page 14) at the
bottom of the mounting plate. Reaching through
upper cabinet, thread power supply cord through
the power supply cord hole in the bottom of the
upper cabinet. See Figure 27.
2. Rotate the microwave upward so the top of the
oven is against the bottom of the upper cabinet or
cabinet frame.
3. ROOF-VENTED INSTALLATION: Align the duct
connector with the vent on top of the microwave
oven. Damper should be on top of tab. Use two
tapping screws (bright-colored) to attach duct
connector to the microwave oven.
See Figure 28, 29.
NOTE: Duct connector must be attached to
microwave oven after microwave oven is
installed.
4. ROOF VENTED INSTALLATION: Install ductwork
through the vent opening in the upper cabinet.
Complete the venting system through the roof
according to the method needed. See Figure 30.
See PREPARE THE VENTING SYSTEM,
STEP 2 on page 8. Use caulking to seal the
exterior roof opening around the exhaust cap.
See Figure 6 on page 8.
5. Use the power supply cord clamp to bundle the
power supply cord. Install the power supply cord
clamp, using a screw as shown in Figure 30, to the
inside of the cabinet.
6. Slide the grease filter into the side slot, then push
up and toward oven center to lock. See Figure 31.
7. Plug in the power supply cord.
8. Read your Owner’s Manual, then check the
operation of your microwave oven.
STEP 6:
ATTACH THE OVEN TO THE WALL
W A R N I N G
Figure 27
power cord
power cord
hole
Figure 28
Figure 29
Figure 30
Figure 31
damper
duct
power
supply
cord
clamp