LG Electronics LMV1630BB Microwave Oven User Manual


 
16
STEP 5: Install The Mounting Plate
Slide exhaust
adaptor into
guides on
rear panel.
Exhaust Adaptor
Damper
(hinge side up)
Locking
Tabs
Guides
Mounting Plate
Back Plate
(1-piece
Mounting Plate)
(3-piece
Mounting Plate)
For Wall-Vented
Make the box cutout for the rear wall duct.
1-piece mounting plate:
Using a pencil, put dots through slots F and G, and
through holes H and I. Remove the mounting plate and
draw lines extending through the points. This will give
the location and size of the box cutout for the rear wall
duct. (Figure 29)
3-piece mounting plate:
Use the wall template to determine the location and size
of the box cutout for the rear wall duct.
Attach the exhaust adaptor to the rear mounting plate
(back plate) wall side. Push in securely until it is past the
top locking tabs and in the lower locking tabs. Take care to
assure the damper hinge is installed so that it is at the top
and that the damper swings freely.
Carefully guide the exhaust adaptor, now attached to the
mounting plate, into the house duct. Before using the
screws to attach the plate to the wall. This will assure
proper alignment for installation.
After completing the installation of the mounting plate,
again check the rear damper for free movement to assure
it will operate properly.
Figure 29
Figure 30