Filter
Top Products
- 15 -
English
Español
OPERATION
SETTING THE CLOCK
The CLOCK pad is used to set the clock. The clock has been
preset at the factory for 12 hours operation. When the range
is first plugged in, or when the power supply to the range has
been interrupted, the timer in the display will show with
power failure PF. You can make a choice between 12-hour
clock and 24-hour clock (refer to the page 16):
1. Press CLEAR/OFF.
2. Press CLOCK.
3. Press 1, 3, and 0 to set the time of
day to 1:30.
4. Press START.
The clock will start.
To set the clock (example below for 1:30):
MINIMUM & MAXIMUM
CONTROL PAD SETTINGS
All of the features listed have minimum and maximum time
or temperature settings that may be entered into the control.
An entry acceptance beep will sound each time a control pad
is pressed.
An entry error tone (3 short beeps) will sound if the entry of
the temperature or time is below the minimum or above the
maximum settings for the feature.
1. Press TIMER ON/OFF twice.
0:00 and HR inside O will appear
and TIMER will flash in the display.
2. Press the number pads to set the
desired time in the display (press
5).
If you make a mistake press the
TIMER ON/OFF and begin again.
3. Press TIMER ON/OFF. The time
will count down with 5:00 and
TIMER will show in the display.
4. When the set time has run out,
End will show in the display. The
clock will sound with 3 beeps
every 15 seconds until TIMER
ON/OFF is pressed.
1. Press TIMER ON/OFF once.
The display will return to the time
of day.
To set the Timer (example for 5 minutes):
To cancel the Timer before the set time has run out:
SETTING THE TIMER ON/OFF
The TIMER ON/OFF serves as an extra timer in the
kitchen that will beep when the set time has run out. It does
not start or stop cooking. The TIMER ON/OFF feature can
be used during any of the other oven control functions.
FEATURE
MIN. TEMP. MAX. TEMP.
/TIME /TIME
BAKE TEMP.
BROIL TEMP.
SELF CLEAN TIME
CONVECTION BAKE/
CONVECTION ROAST
COOK & WARM
RADIANT ELEMENT
WARMING ZONE
PROOF
170°F / 75°C
LO (400°F)
2 hours
300°F / 150°C
550°F / 285°C
HI (550°F)
4 hours
550°F / 285°C
170°F (75°C) / 3 hours
Default: 12 Hr.
Default: 2 Hr.
Default: 12 Hr.
If the remaining time is not in the display, recall the
remaining time by pressing the TIMER ON/OFF.
Note:
1. If you press TIMER ON/OFF once, it allows you to set the
time in seconds.
(for example: if you press 5 and 6, it means 56 seconds)
2. If you press TIMER ON/OFF twice, it allows you to set the
time in minutes.
(for example: if you press 5 and 6, it means 56 minutes)
Note:
If TIMER ON/OFF is
not pressed, the timer will
return to the time of day.
Note: