LG Electronics LRSC21935TT, LSRC21935SW, LSRC21935SB Refrigerator User Manual


 
8
Installation
Water connection instruction guide
Read all directions carefully before you begin.
Connecting
the refrigerator
to a water source
Connect to potable water supply only.
Warning
If operating the refrigerator before installing the water connection, turn ice maker
to the OFF position to prevent operation without water.
All installations must be in accordance with local plumbing code requirements.
Use copper tubing and check for leaks.
Install copper tubing only in areas where temperatures will remain above freezing.
It may take up to 24 hours for your ice maker to begin producing ice.
IMPORTANT
The ice maker water valve contains a flow washer which is used as a water
pressure regulator.
The ice maker needs to be connected to a cold water line with water pressure
207 ~ 827 kPa (30 ~ 120 psi).
If a problem occurs, call your utility company.
Cold water supply
Standard screwdriver
7/16 - inch and 1/2 - inch open-end wrenches or two adjustable wrenches
1/4 - inch nut driver
1/4 - inch drill bit
Hand drill or electric drill (properly grounded)
Tools required
Your refrigerator dealer has a kit available with a 1/4 - inch saddle-type shut - off valve,
a union, and copper tubing. Before purchasing, make sure a saddle-type valve
complies with your local plumbing codes. Do not use a piercing-type or 3/16 - inch
saddle valve which reduces water flow and clogs more easily.
NOTE