Filter
Top Products
How to dismantle parts
Freezer
compartment
lamp
Dispenser lamp
Freezer
compartment
shelf
Door rack and
support
Ice storage bin
After dispenser
is used
Seperate the lamp by pulling it out, and then
remove the lamp. Max. 15 W bulb for
refrigerator is used and can be purchased at a
service center.
To remove a shelf, lift the left part of the shelf
a bit, push it to the direction (), lift the right
part to the diretion
(
)
, and take it out.
Lift the door rack holding both sides () and
pull it out to
(
)
direction.
The water collector has no self-drainage
function. So it should be cleaned regularly.
Remove the cover by pressing the left side of
water collector cover and dry it with a cloth.
Press the point marked as shown in the figure
to the right to remove the water collector
cover.
Hold the ice storage bin as shown in the right
figure and pull it out
(
)
while slightly lifting it
().
It is recommended not to dismantle the ice
storage bin unless it is necessary.
Be sure to use both hands when removing
the ice storage bin, so as not to drop it on the
floor.
If the ice storage bin does not fit well, slightly
rotate the rotating device.
•
Dismantling is done in the reverse sequence of assembly.
Be sure to unplug the power plug before dismantling and assembly.
Never apply severe force to dismantle parts. Parts may be damaged.
NOTE
23
Care and maintenance
Separate the lamp by pulling it out
(
➂
)
while
slightly striking
(➀) and rotating
(
➁
)
the lamp
cover.
Turn the bulb counterclockwise. Max. 40 W
bulb
for refrigerator is used and can be purchased at
a service center.