Filter
Top Products
12
Height adjustment
Makethemlevelbyinsertingflat (
-
type)driverintothegrooveoftheleftheightadjusting
screwand rotating itclockwise( ).
Make them level by inserting flat (
-
type) driver into the groove of the right height
adjusting screw and rotating it clockwise(
Adjust the level when the refrigerator door is lower than the freezer door during the
use of the refrigerator.
1. Using the wide side of the tool for adjustment , turn the keeper nut
Keeper nut
Adjustment
hinge pin
Tool for
adjustment
Up
Down
Installation
CAUTION
).
The refrigerator doorwill close smoothly by raising the frontside byadjusting the
height adjusting screw. If the door doesnot close properly becauseit is improperly
adjusted, the performance of the refrigerator will be affected.
If the freezer
compartment door
is lower than the
refrigerator
compartment door
If the freezer
compartment door
is higher than the
refrigerator
compartment door
-
Type 1
After leveling the
door height
Do not forcetoo hard to level the height. The hinge pin can bepulled out.
(Adjustable range of height is a maximum of 2" (5 cm).
( )
clockwise to loosen the keeper nut.
2. Using the narrow side of the tool for adjustment, turn the adjustment hinge pin
( ) clockwise or ( ) counterclockwise to level the refrigerator and
freezer door.
3. After setting the level of the door, turn the keeper nut( ) counterclockwise to
tighten.
If the freezer
compartment door
is higher than the
refrigerator
compartment door
-Type 2
(First identify your adjusting screw type, it could vary)