Filter
Top Products
Operation
Self-diagnosis function operates when a problem occurs in the unit. When an error
occurs in the unit. Immediately contact the service center without turning the
power OFF. If the power is OFF, it will take the engineer longer to find out where
the fault occurs.
The pressing of any function buttons will not alter the temperature setting when a
fault occurs.
Water is cooled while stored in the water tank in the refrigerator compartment, and
then sent to the dispenser.
Ice is made in the automatic ice maker and sent to the dispenser divided into crushed
or cubed form ice.
An alarm will sound 3 times when the refrigerator door is left open for more than 1
minute. This alarm will be rung at an intervals of 30 sec. and stop at the close of the
door. If the alarm sound does not stop even after the freezer and refrigerator
compartment doors are closed, contact the service center.
Door open alarm
Self-diagnosis
(fault detection)
function
How ice/cold
water is supplied
How to use
dispenser
Automatic ice maker and dispenser
Select one among crushed ice, water, and cubed ice and slightly press the push
switch with a glass or other container.
Crushed ice
Light the crushed ice
indicating lamp by
pressing the selection
button.
•
C
rushed
ice will be
dispensed by pressing the
push switch with a glass.
Water
Light the water
indicating lamp by
pressing the selection
button.
•
Water will be dispensed
by pressing the push
switch with a glass.
Cubed ice
Light the cubed ice
indicating lamp by
pressing the
selection button.
•
Cubed ice will be dispensed
by pressing the push
switch with a glass.
•
It is normal that the water is not very cold at first. If you want colder water, add
ice into the glass.
NOTE
11