Liebherr 7084 750-00 Refrigerator User Manual


 
5
Setting up
Avoid locating the appliance in direct sunlight or near heat
sources such as an oven or a radiator.
The fl oor should be level and even. You can compensate for
an uneven fl oor by adjusting the adjustable feet.
Standard EN 378 specifi es that the room in which you
install your appliance must have a volume of 1 m³ per 8 g
of R600a refrigerant used in the appliance, so as to avoid
the formation of infl ammable gas/air mixtures in the room
where the appliance is located in the event of a leak in the
refrigerant circuit, The quantity of refrigerant used in your
appliance is indicated on the type plate on the inside of the
appliance.
The appliance is set to operate within specifi c ambient
temperature limits according to its climate rating. These
temperature limits should not be exceeded. The correct
climate rating for your appliance is indicated on the type
plate.
SN - ST = +10 ° C to +38 °C
SN – T = +10 °C to +43 °C
Switching the appliance on and off
You are recommended to clean the appliance before switching
it on for the fi rst time (see “Cleaning”). Con-
nect the appliance to the mains – the appli-
ance is on.
To switch the appliance off : Keep ON/
OFF button pressed for 3 sec. so that the
temperature display goes out.
To switch the appliance on : Press the
ON/OFF button until the Display lights up.
Operating and control elements
Temperature display
Temperature setting button
Audible warning on/off button
Interior light on/off button
Child - proof lock
On/off button
Ventilation on/off button
Setting the temperature
To reduce the temperature : Press the button.
To increase the temperature : Press the button.
While you are entering
the temperature, the set
temperature will fl ash on
the display.
You can change the
settings in increments of
1
o
C briefl y pressing the
button again.
The electronic controls
will switch over automatically about 5 seconds after the
last time you pressed the button, and the actual tempera-
ture will be displayed.
Factory temperature setting is +12
o
C.
If F1appears in the display, the appliance has a fault. Consult
your nearest customer service point.