Filter
Top Products
u
Examine the unit and packaging for shipping damage.
Contact the carrier immediately if you suspect there is
any damage.
u
Note the type (model, number), index, appliance/serial
number, date of purchase and where purchased on the
spaces provided in see Appliance Information.
u
Remove anything attached to the rear or side walls of
appliance that would prevent proper installation or
impede proper ventilation.
If the appliance is set up in humid areas, condensation may
build on the outside of the appliance.
u
Always ensure proper ventilation.
3 Changing the door hinges
Make sure you have the following tools on hand:
q
Hex wrench 13
q
Cordless screwdriver Torx 15, 20, 25, 30
Push the appliance 2/3 of the way into the recess.
Disconnect the power plug.
Open the doors.
3.1 To detach the soft stop
mechanism*
HC1011, HC1060
CAUTION
Risk of injury if soft stop contracts!
u
Detach with care.
Fig. 1
u
Unscrew retainer
Fig. 1 (1)
.
u
Unscrew ball stud
Fig. 1 (3)
together with the soft stop
mechanism
Fig. 1 (2)
from the door and set to one side.
3.2 Reversing the door
Fig. 2
u
Lift off covers
Fig. 2 (5,6,7,8)
using a slot screwdriver.
u
Just loosen top and bottom screws
Fig. 2 (9)
on the body
of the appliance.
u
Push doors outwards and unhook.
u
Swap screws
Fig. 2 (9)
to the opposite side and screw
them in a little.
CAUTION
Risk of injury if hinges fold!
u
Leave hinges open.
u
Undo screws
Fig. 2 (10)
and change over the hinges
diagonally.
The screws
Fig. 2 (10)
are self-tapping: use a cordless
screwdriver.
u
Tighten the hinges.
u
Close off the now unused fastening holes with the
plugs
Fig. 2 (11)
supplied.
u
Hang doors on the pre-fitted screws
Fig. 2 (9)
and tighten
screws.
3.3 Re-attaching the soft stop
mechanism*
HC1011, HC1060
Fig. 3
u
Screw on retainer
Fig. 3 (1)
.
Changing the door hinges
3