Filter
Top Products
·
Before connecting the appliance to electrical
power supply, leave it to stand for about 4 hours,
which will reduce the possibility of malfunctions
in the cooling system due to transport handling.
·
Clean the appliance thoroughly, especially in the
interior (See Cleaning and Maintenance).
·
In case the interior accessories are not correctly
placed, rearrange them as described in chapter
"Description of the Appliance".
.
Instructions for Use
These instructions for use are intended for the user.
.
They describe the appliance and correct operating
procedures for safe use .
SAVE THESE INSTRUCTIONS:
·
Try not to open the door too often, especially when
the weather is hot and humid. Once you open the
door , close it as soon as possible. This is
especially important if you have an upright model .
·
Every now and then check if the appliance is
sufficiently ventilated ( adequate air circulation
behind the appliance ).
·
Set the thermostat from higher to lower settings as
soon as possible (depends on how loaded the
appliance is, ambient temperatures etc.).
·
If the gasket is damaged or the door seal is poor,
energy consumption is substantially higher. To
restore efficiency, replace the gasket.
·
Always consider instructions stated in sections
Positioning and Energy Saving Tips, otherwise
the energy consumption is substantially higher.
Tips for Energy Saving
screwdriver.
for EWWC16MCG & EWWC30MCG )
2
Before Putting Into Use
Before Putting Into UseBefore Putting Into Use
Before Putting Into Use
To save shipping space and avoid damage of
the unit during transportation, the door handle
of this unit is shipped unassembled. Before
putting the unit into use you are kindly asked to
assemble the door handle as follows:
Locate the door handle and 2 screws attached
inside the cabinet, and prepare an appropriate
To Assemble Door Handle
(Door handle assembling
With the 2 screws attached, fasten the door
illustrated. Be sure that the screws must point
when doing so.
handle onto the frame of the door panel as
to the holes on the frame of the door panel