Filter
Top Products
EN
7
OPERATING YOUR APPLIANCE
MCWC50DSTF: Wine Cooler
The temperature range of the wine cooler is for 39°F ~
64°F (4°C ~ 18°C) +/- 5°F.
Temperature Recommendations:
Red Wine: 54°F ~ 61°F (12°C ~ 16°C)
White Wine: 43°F ~ 50°F (6°C ~ 10°C)
The display indicates the average temperature of the appliance at the moment.
Pre-Set Wine Zones
Press the “RED” or “WHITE” pads to choose preset storage conditions for either red or white
wine. (The indicator light “RED” or “WHITE” will illuminate accordingly.)
The programmed temperature for red or white wine will be displayed for a few seconds.
Manual Temperature Setting
The temperature of the wine cooler can be set anywhere between 39°F ~ 64°F (4°C ~ 18°C) by
pressing temperature up ▲ and temperature down ▼pads as follows:
1) Press the [SET] pad until you hear a “Beep” sound (approximately 2 seconds).
2) Press the ▲▼ pads to increase or decrease the desired temperature in increments of
one degree.
3) Press the [SET] pad to confirm your desired temperature setting. If no pad is pressed
within 10 seconds, your select temperature setting will be automatically confirmed.
NOTE:
To select temperature display between Celsius (°C) or Fahrenheit (°F), press the “▲” pad for
approximately 2 seconds.
MCBC58DSTF: Beverage Cooler
The temperature range of the beverage cooler is for 39°F ~
54°F (4°C ~ 12°C). +/- 5°F.
The display indicates the average temperature of the
appliance at the moment.
NORMAL Temperature Setting
When the appliance is switched on, or the “NORMAL” pad is pressed, the appliance runs on the
temperature setting of 45°F (7°C) and the “NORMAL” indicator light will be illuminated.
Manual Temperature Setting
The temperature of the beverage cooler can be set anywhere between 39°F ~ 54°F (4°C ~ 12°C)
by pressing temperature up ▲ and temperature down ▼pads as follows:
1) Press the [SET] pad until you hear a “Beep” sound (approximately 2 seconds).
2) Press the ▲▼ pads to increase or decrease the desired temperature in increments of
one degree.
3) Press the [SET] pad to confirm your desired temperature setting. If no pad is pressed
within 10 seconds, your select temperature setting will be automatically confirmed.
NOTE:
The “MANUAL” indicator light will be illuminated while you are manually setting the temperature
on the beverage cooler.
To select temperature display between Celsius (°C) or Fahrenheit (°F), press the “▲” pad for
approximately 2 seconds.
The following is applicable to both MCWC50DST
F
and MCBC58DST
F
:
The indicator will remain ON during refrigeration cycle and will be OFF during
idle cycle.
To switch the Interior light ON/OFF, press the pad.